Search
Now showing items 971-980 of 1083
ASME Y14.5.2: Certification of Geometric Dimensioning and Tolerancing Professionals
Abstract: This Standard establishes certification requirements for a geometric dimensioning and tolerancing professional (GDTP). Certification shall be based on either ASME Y14.5M-1994 or ASME Y14.5-2009, its appendices, and the ...
ASME B16.47: Large Diameter Steel Flanges NPS 26 Through NPS 60 Metric/Inch Standard
Abstract: General This Standard covers pressure–temperature ratings, materials, dimensions, tolerances, marking, and testing for pipe flanges in sizes NPS 26 through NPS 60. Included are flanges with rating class designations ...
ASME STP-PT-081: CYCLIC STRESS-STRAIN CURVES
Abstract: INTRODUCTION AND DESCRIPTION OF THE PROBLEM Cyclic stress-strain curves describe the stress-strain behavior under cyclic loads. Usually, the cyclic stress amplitude Δσ/2 is plotted as a function of the cyclic ...
ASME B16.18: Cast Copper Alloy Solder Joint Pressure Fittings
Abstract: This Standard for cast copper alloy solder joint pressure fittings designed for use with copper water tube establishes requirements for (a) pressure–temperature ratings (b) abbreviations for end connections (c) sizes ...
ASME A17.3: Safety Code for Existing Elevators and Escalators - Incorporates Interpretation No. 10: APRIL 2015 THR
Abstract: There is no abstract information for this document.
Glossary of Terms for Mechanical Fasteners: ASME B18.12
Abstract: This Standard is a summary of mechanical fastener terminology, related characteristics, and manufacture.
(a) Fastener.
A fastener is a mechanical device designed specifically to hold, join, couple, assemble, or maintain ...
Guidelines for the Evaluation of Uncertainty of Test Values Associated With the Verification of Dimensional Measuring Instruments to Their Performance Specifications: ASME B89.7.6
Abstract: This Standard provides guidelines for evaluating the uncertainty of test values obtained when verifying dimensional measuring instruments1 to an ASME B89 testing protocol.
The scope is limited to the case in which the ...
Hydromassage bathtub systems: ASME A112.19.7
Abstract: This Standard specifies general requirements, test methods, and markings for whirlpool and air-jetted bathtubs and suction fittings used in hydromassage bathtub systems that incorporate a bathtub and circulation pump.
The ...
Hydrogen Piping and Pipelines: ASME B31.12 ERTA
Abstract: Paragraph GR-3.9.2 was inadvertently omitted from ASME B31.12-2019, page 48. Pipe may be bent and components may be formed by any hot or cold method that is suitable for the material, the intended service, and the severity ...
Malleable Iron Threaded Pipe Unions Classes 150, 250, and 300: ASME B16.39
Abstract: This Standard covers threaded malleable iron unions, Classes 150, 250, and 300.
It also contains provisions for using steel for NPS 1∕8 unions.
This Standard includes
(a) design
(b) pressure–temperature ratings
(c) ...