درباره ما
ARMY - AT - Tank-Automotive and Armaments Command: Recent submissions
Now showing items 441-460 of 832
-
A-A-52545B
Abstract: This CID covers two types of heaters of 28 volt (V) direct current (dc) nominal rating, used for heating crew and engine compartments of military vehicles or equipment. Type I heaters are intended for use on military ... -
A-A-52473
Abstract: The General Services Administration has authorized the use of this commercial item description (CID) as a replacement for MIL-I-62521(AT) which is canceled. -
A-A-59326/5B
Abstract: This specification covers a female by internal pipe thread, type V coupling half. -
A-A-59785
Abstract: This commercial item description (CID) covers a two part epoxy resin system suitable to be used in the production of advanced composite materials.Subject(s) : Epoxy , Resin , -
MIL-HDBK-507 VALID NOTICE 1
Abstract: This Standard covers procedures for the flash welding of standard low carbon steels with a carbon content not greater than 0.23. Intended Use: The procedures covered by this specification are intended for ...Subject(s) : Flash welding , low carbon steel , Low carbon steel , flash welding , Steel , welding of , Welding , Welding , low carbon steel , -
A-A-52470A
Abstract: This CID covers requirements for a filter assembly with a coarse filtration element and the replacement element for use in the fuel system of internal combustion engines and accessories.Subject(s) : Assembly , Internal Combustion Engine , -
MIL-PRF-32214
Abstract: This specification establishes, unless otherwise specified, the minimum requirements for engineering acceptance for the operation, performance, and reliability of Exterior Lighting Devices, for military vehicles, with Light ...Subject(s) : Water submersion test , -
MIL-DTL-14465F
Abstract: This specification covers two types of vehicular composite light assemblies each consisting of a service driving light, infrared driving light, blackout driving light, and a blackout marker light. The vehicular composite ...Subject(s) : Blackout , Driving , Filter , Infrared , Lens , Sealed beam , -
A-A-52152A
Abstract: This CID covers requirements for tubular, thermal, insulation sleeving, hereinafter called "insulation sleeving". The insulation sleeving is intended for covering heater exhaust ducts, heater ducts or tubes and pipes ... -
MIL-DTL-46789D
Abstract: This specification covers an auxiliary firing blasting machine, hereinafter to be referred to as "assembly", which produces an electric output through generator action for emergency firing of fire power on full tracked ...Subject(s) : Electrical generator , Hand generator , Manual generator , Rotary generator , -
MIL-PRF-62439B
Abstract: This specification covers an electrohydraulic main fuel control used in the gas turbine engine of the M1 tank, referred to herein as "assembly." The assembly is an electrohydraulic device which converts electrical commands ...Subject(s) : Check valve , Cutoff valve , Inlet guide ramp , Power turbine starter , -
MIL-DTL-62542C VALID NOTICE 1
Abstract: This specification covers a Ball Screw Linear Actuator (BSLA) for deployment of stabilizing outriggers for the M860A1 Patriot Semitrailer (see 6.1). Intended Use: The intended use of the BSLA covered ...Subject(s) : M8601 semitrailer , Outriggers , Patriot , Return assembly , Rod end bearing , Stabilizing , -
A-A-52524/11
Abstract: This CIDSS covers seals to be used as rotary shaft seals to retain oil and other fluids. -
A-A-52447A
Abstract: This commercial item description (CID) covers requirements for mechanical fuel pumps of the cam-actuated, diaphragm type used on carburetor-fed internal combustion engines. The rated flow of the fuel pumps ranges from 10 ...