درباره ما
JSA JIS B 0405 ERTA
General Tolerances - Part 1: Tolerances for Linear and Angular Dimensions Without Individual Tolerance Indications
Organization:
JSA - Japanese Standards Association
Year: 2010
Abstract: This Standard is intended to simplify drawing indications, and it specifies general tolerances for linear and angular dimensions without individual indications in four tolerance classes.
Remarks 1. The concepts behind the general tolerancing of linear and angular dimensions are described in Annex A.
This Standard applies to the dimensions of parts which have been produced by metal removal or parts which have been formed from sheet metal.
2. These tolerances may be suitable for use with materials other than metal.
3. Similar standards exist or are planned. For example, see JIS B 0403 for castings.
Remarks 1. The concepts behind the general tolerancing of linear and angular dimensions are described in Annex A.
This Standard applies to the dimensions of parts which have been produced by metal removal or parts which have been formed from sheet metal.
2. These tolerances may be suitable for use with materials other than metal.
3. Similar standards exist or are planned. For example, see JIS B 0403 for castings.
Collections
:
-
Statistics
JSA JIS B 0405 ERTA
Show full item record
| contributor author | JSA - Japanese Standards Association | |
| date accessioned | 2017-09-04T18:50:13Z | |
| date available | 2017-09-04T18:50:13Z | |
| date copyright | 2006.10.01 (R 2010) | |
| date issued | 2010 | |
| identifier other | KUBUJBAAAAAAAAAA.pdf | |
| identifier uri | http://yse.yabesh.ir/std;jsein=author:%22NAVY%20-%20YD%20-%20Naval%20Facilities%177ngineering%20Command%226EFDEC9FCD/handle/yse/231609 | |
| description abstract | This Standard is intended to simplify drawing indications, and it specifies general tolerances for linear and angular dimensions without individual indications in four tolerance classes. Remarks 1. The concepts behind the general tolerancing of linear and angular dimensions are described in Annex A. This Standard applies to the dimensions of parts which have been produced by metal removal or parts which have been formed from sheet metal. 2. These tolerances may be suitable for use with materials other than metal. 3. Similar standards exist or are planned. For example, see JIS B 0403 for castings. | |
| language | English | |
| title | JSA JIS B 0405 ERTA | num |
| title | General Tolerances - Part 1: Tolerances for Linear and Angular Dimensions Without Individual Tolerance Indications | en |
| type | standard | |
| page | 1 | |
| status | Active | |
| tree | JSA - Japanese Standards Association:;2010 | |
| contenttype | fulltext |