MIL-DTL-20176G

Abstract

This specification covers smooth bore, sewage discharge, and oily waste discharge rubber hose and hose assemblies. <br>Sewage hose and oily waste will be of the following types, classes, and sizes, as specified (see <a>6.2</a>): <br>Type I - Sewage hose. <br>Size 1.5 - 1.5 inches (38.10 millimetre (mm)) nominal inside diameter (id). <br>Size 2.5 - 2.5 inches (63.50 mm) nominal id. <br>Size 4.0 - 4.0 inches (101.60 mm) nominal id. <br>Type II - Oily waste hose. <br>Size 2.5 - 2.5 inches (63.50 mm) nominal id. <strong>Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data which may improve this document should be sent to: Commanding Officer (Code 15E2), Naval Construction Battalion Center, 1000 23rd Avenue, Port Hueneme, CA 93043-4301, by using the Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.</strong> <br>Class 1 - Noncollapsible. <br>Class 2 - Collapsible. <b><u>Intended Use:</u></b> Hose and hose assemblies covered by this specification are intended as a means of transferring ship sewage and oil waste to receiving facilities as follows: a. Surface ship sewage from collection, holding and transfer systems to shore or barge receiving facilities - 4-inch (102 mm) "SEWAGE" hose. b. Submarine sewage from sanitary tanks to shore, tender or barge receiving facilities 2.5-inch (64 mm) "SEWAGE" hose. c. Surface ship and submarine oily waste from bilges to shore, barge, or tender receiving facilities -2.5-inch (64 mm) "OILY WASTE" hose. d. Smaller surface vessel or barge sewage from sanitary tanks to shore or tender receiving facilities -1.5-inch (38 mm) "SEWAGE" hose. <br>