درباره ما
ECIA - Electronic Components Industry Association: Recent submissions
Now showing items 381-400 of 507
-
ECA EIA-540CAAA
Abstract: The relay socket, of assessed quality, covered by this detail specification have:
a) the ability to mate with 10 ampere-rated hermetically sealed relays.
b) a rated voltage not to exceed 250 volts (rms) at sea ... -
ECA 473
Abstract: This standard covers definitions, classifications, terminology, notation, and performance characteristics of relays for general switching purposes. It also includes military relays, relays for use in electronic circuits, ... -
ECA EIA/ECA-575-A
Abstract: This standard covers thick film general purpose rectangular leadless discrete fixed resistors with temperature coefficients of ± 350 PPM/°C (ranging from ± 50 PPM/°C to ± 350 PPM/°C) and greater ... -
ECA 180
Abstract: This specification covers iron core, power transformers up to 10 KVA for use in electronic equipment where long life, reliability and continuity of operation is essential. -
ECA 700A0AA
Abstract: This specification covers rectangular shielded connectors with ribbon style contacts on 1.27 x 1.65 mm [.050 x 0.065 in] contact spacing. Connector polarization is achieved by the trapezoidal configutation of the shell. ... -
ECA IS-43AB
Abstract: This Detail Specification defines Type 1 Nonplenum cable used with the Token Ring LAN Cabling System. Type 1 NP consists of 2 twisted pairs of Data Grade Media (DGM) shielded with aluminum tape and braided shields, all ... -
ECA EIA-364-55-A
Abstract: This standard establishes test methods to determine the current cycling characteristics of mated electrical contacts, connectors and sockets using, but not limited to, crimp, press-fit contacts, insulation displacement ... -
ECA RS-192-A
Abstract: INTRODUCTION
This standard, which shows quartz crystal unit holder outlines and pin connections, includes the outlines previously shown in RETMA Standard RS-192, July 1957; those of interest to the U. ... -
ECA EIA/ECA-958
Abstract: Description
This specification defines the qualification program for surface mount Common Mode Chokes. The qualification program is defined in Table 1. Specification sheets can be added, as required, ... -
ECA TEP105-18
Abstract: This procedure is recommended to demonstrate the degree of uniformity of any color field of a display device. For Simplification, references are made to a CRT monitor, but the principles of this procedure can be applied ...Subject(s) : color difference , color purity , field uniformity , luminance variation , -
ECA 186-12E
Abstract: PURPOSE
This test is performed to determine the effect of storing or operating component parts at elevated temperatures for various time periods. Different degrees of severity as prescribed by temperature ... -
ECA 199-A
Abstract: General
This standard refers to solid- and semi-solid-dielectric coaxial-cable transmission lines conasi sting of one or two inner conductors.
Coaxial Cables
Basically, a coaxial ... -
ECA 181
Abstract: This standard covers iron core charging reactors for use in radar transmitters and similar equipment where long life, reliability and continuity of operation is essentiai. -
ECA 359-A-1
Abstract: This Standard establishes and defines the general requirements for packaging and packing of electrical and electronic components for domestic shipment and storage at the users facility for a period of 90 days. -
ECA RS-448
Abstract: This standard establishes uniform test methods for those tests which are peculiar to electromechanical switches, except those classified as industrial controls (as defined in ANSI C19.3). In case of conflict between this ... -
ECA 186-14E
Abstract: PURPOSE
This test is intended to determine the effectiveness of panel seals on electronic components which are intended for mounting through holes in panels or enclosures. The panel seals are exposed to water under ...