درباره ما
ECIA - Electronic Components Industry Association: Recent submissions
Now showing items 281-300 of 507
-
ECA RS-448-4
Abstract: PURPOSE
The Logic Level Endurance Test is a measure of the ability of a switch to control electrical loads in which the applied voltage exceeds the melting voltage of the switch contact material and is less than the ... -
ECA EIA/ECA-962
Abstract: This specification defines the qualification program for low voltage, supplemental fuses. Fuses covered will be limited to axial-leaded, radial-leaded and surface mount configurations having a current rating of no greater ... -
ECA 407-A
Abstract: This standard provides procedures for inspecting and testing electromagnetic relays for the applicable mechanical, electrical, and environmental requirements of individual relay specifications. The standard is intended for ... -
ECA 545
Abstract: PURPOSE
This test is performed to determine the level at which electrostatic discharge occurs through or around a manually operated electromechanical switch, which is not equipped with a ground plane ... -
ECA EIA-5200000-D
Abstract: This generic specification relates to special-use electromechanical switches of certified quality. Switches covered by this specification:
a) are devices that open, close, or change the connection of a circuit by the ... -
ECA EIA/ECA-364-110
Abstract: This standard establishes a test method to expose connectors and sockets to extremes of high and low temperatures at a specified ramp up and ramp down rate.
NOTE — If the ramp time between temperature extremes ... -
ECA 520AAAA-A
Abstract: The family of momentary contact, nonsensitive pushbutton switches covered by this detail specification:
a) mount in a panel hole with a clearance diameter for a 1/4-32UNEF-2A thread.
b) have a maximum rated voltage ... -
ECA 700AOAC
Abstract: Scope and Purpose
This specification covers interconnect systems typically used for memory card type devices, specified in PCMCIA PC Card Standard - JEIDA Specific Extensions or JEIDA IC Memory Card ... -
ECA 188
Abstract: This standard covers the establishment of a series of dimensional systems and nomenclature to serve as a guide in the coordination of equipment design and design of machinery for automatic manufacture.
Basic Module: ... -
ECA 186-11E
Abstract: PURPOSE
This test is conducted for the purpose of determining the resistance of a component part to exposures at ! extremes of high and low temperatures in air, and to the shock of alternate exposures ... -
ECA 186-10E
Abstract: PURPOSE
This test is performed to determine the effect of normal soldering operations on component parts. Excessive changes in electrical characteristics or mechanical damage to a component part are ... -
ECA TEP105-13
Abstract: This method covers a test procedure for the measurement and evaluation of non-glare surfaces in terms of specular gloss for screened tubes and panels at 60°& 45° and unscreened panels & coverplates at 60°, ... -
ECA TEP105-7-A
Abstract: The purpose of this test is to measure the profile of a line on the face of monochrome cathode ray tube (CRT) in order to estimate the resolution capacity of the CRT. Since the display on a CRT often consists of a series ... -
ECA EIA/ECA-364-26B
Abstract: This standard establishes a test method to assess the effects of a controlled salt-laden atmosphere on electrical connector components, finishes, and mechanisms and permit electrical readings to be taken after exposure ... -
ECA 500-A
Abstract: This test method applies to the measurement of x-radiation emitted from projection cathode-ray tubes.
For some applications the test procedures described in Recommended Standard EIA-503 "Recommended Practice for ... -
ECA CB-14
Abstract: PURPOSE AND SCOPE
The purpose of this document is to review contact lubricants used in signal contact systems for electronics. Factors affecting the use of lubricants will be discussed including ...