درباره ما
NAVY - SH - Naval Sea Systems Command (Ship Systems): Recent submissions
Now showing items 181-200 of 2792
-
MIL-STD-2119A
Abstract: This standard establishes design requirements governing printed-wiring electrical backplane assemblies consisting of rigid printed-wiring boards in accordance with MIL-P-55110 on which separately manufactured connector ...Subject(s) : Multilayer printed boards. , Solderless wrapped interconnections. , Standard Hardware Acquisition and Reliability Program , (SHARP). , Tuning fork contacts. , -
A-A-59817
Abstract: This Commercial Item Description (CID) covers the physical and performance characteristics of an extruded U-nut, 3/8 – 16UNC – 2B inch thread size, wide panel range.Intended Use: ...Subject(s) : Clip-on nut , -
MIL-F-23788A
Abstract: This specification covers cylindrical shaped air filled plastic fenders for protection of boats and harbor craft from damage when alongside other boats or pier. Intended Use: This specification covers three ...Subject(s) : Grommet , Plastisol , Polyvinyl chloride , Tear strength , -
MIL-H-17666A
Abstract: This specification covers flexible bronze base and couplings of the corrugated type for high pressure air service (up to 3300 p.s.i.). -
MS15577 REV A
Abstract: This standard establishes the overall dimensions and detail engineering requirements for incandescent lamps, type TS-33. The item covered hereon is standard for use in the design of new equipment procured by the Bureau of Ships. -
MIL-F-16377/17A
Abstract: This specification sheet is approved for use by the Naval Sea Systems Command and is available for use by all Departments and Agencies of the Department of Defense.
The complete requirements for procuring the fixtures ... -
MIL-V-24658
Abstract: This specification covers the design, construction, test, and operating requirements for quiet design, high pressure air or nitrogen reducing valve manifolds. Intended Use: Manifolds specified herein are ... -
MIL-I-24768/11
Abstract: This specification is approved for use by all departments and agencies of the Department of Defense.
The requirements for acquiring the insulation material described herein shall consist of this specification ... -
MIL-STD-438E NOTICE 1
Abstract: FOREWORD
1. This standard covers requirements for basic submarine piping system components. It is not the intension herein to include every conceivable component, valve or fitting that might be used ... -
DOD-STD-2188
Abstract: This standard provides the requirements for static and centrifugal casting of QQ-T-390, grade 2 babbitt on steel or bronze bearing shells. Intended Use: This standard is intended to provide the procedures ...Subject(s) : Babbitting , Bearing , shells , babbitting , Casting , static and centrifugal , babbitt , Inboard shafting , babbitting , Reduction gears , babbitting , Tin-based babbitting , Tinning , shell surfaces , Turbines , main propulsion , babbitting , -
MIL-DTL-32353A
Abstract: This specification covers a single classification of synthetic steam turbine, hydraulic, and gear lubricating oil, moderate service, for use in main and auxiliary turbines, gears, air compressors, and certain hydraulic ...