درباره ما
Standard Test Method for Specific Aqueous Conductance of Trichlorotrifluoroethane
ASTM D3448-10
Organization:
ASTM - ASTM International
Year: 2025
Abstract: 3.1 This test method allows for the determination of ionizable contaminants (expressed in terms of ppb of HCl) in trichlorotrifluoroethane via measurement of specific aqueous conductance. 3.2 This test method can be used for establishing manufacturing and purchasing specifications.
Collections
:
-
Statistics
Standard Test Method for Specific Aqueous Conductance of Trichlorotrifluoroethane
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T19:25:17Z | |
| date available | 2025-09-30T19:25:17Z | |
| date copyright | 2025 | |
| date issued | 2025 | |
| identifier other | d3448-10r25.pdf | |
| identifier uri | http://yse.yabesh.ir/std;query=authoCA58ear3081D206861598F1EFDEC014A/handle/yse/343423 | |
| description abstract | 3.1 This test method allows for the determination of ionizable contaminants (expressed in terms of ppb of HCl) in trichlorotrifluoroethane via measurement of specific aqueous conductance. 3.2 This test method can be used for establishing manufacturing and purchasing specifications. | |
| language | English | |
| title | Standard Test Method for Specific Aqueous Conductance of Trichlorotrifluoroethane | en |
| title | ASTM D3448-10 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2025 | |
| contenttype | fulltext | |
| scope | 1.1 This test method covers the determination of aqueous conductivity due to ionizable contaminants extracted from trichlorotrifluoroethane. The value of 1.9 μS/cm as maximum specific aqueous conductance corresponds to 0.1 ppm of chloride ion (100 ppb). It was calculated by putting the solvent specification of 0.1 ppm chloride into the equation of the subject method to find C2 − C1 equals 19.08. The specific conductance due to contaminants from the solvent was then calculated as follows: 1.2 The above is exclusive of the background specific conductance of the water used in the analysis. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3.1 Exception—Values are stated in inch-pound units in Fig. 1. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 6. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D3448-10R25 |