درباره ما
Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders
ASTM D4242-25
Organization:
ASTM - ASTM International
Year: 2025
Abstract: 5.1 This test method is useful for selecting coating powders of similar characteristics of melt flow under minimal shear. It is not recommended as an absolute measurement, but rather as a comparative measurement of samples on the same panel measured at the same time.
Collections
:
-
Statistics
Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T19:25:34Z | |
| date available | 2025-09-30T19:25:34Z | |
| date copyright | 2025 | |
| date issued | 2025 | |
| identifier other | d4242-25.pdf | |
| identifier uri | http://yse.yabesh.ir/std;query=authoCA58ear3081D206861598F1EFDEC014A/handle/yse/343468 | |
| description abstract | 5.1 This test method is useful for selecting coating powders of similar characteristics of melt flow under minimal shear. It is not recommended as an absolute measurement, but rather as a comparative measurement of samples on the same panel measured at the same time. | |
| language | English | |
| title | Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders | en |
| title | ASTM D4242-25 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2025 | |
| contenttype | fulltext | |
| scope | 1.1 This test method specifies a method for determining the flow characteristics of a fused thermosetting coating powder down a plane inclined at a set angle to the horizontal. This test method gives an indication of the degree of melt flow that may occur during the curing of the coating powder. This characteristic contributes to the coherence of the coating, to its surface appearance and to the degree of coverage over sharp edges (see Test Method D2967), however, it should not be used as the sole factor for judgment. This test method acts as a useful method for checking for batch to batch variation in the behavior of a given coating powder. Correlation between the results from coating powders of differing composition is not to be expected. This test method is unlikely to yield meaningful results with coating powders which have gel times of less than one minute at the test temperature (see Test Method D4217). Oven drafts, angle of inclination and pellet variations significantly affect results making inter-lab reproducibility somewhat difficult to correlate. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D4242-25 |