درباره ما
ISO - International Organization for Standardization: Recent submissions
Now showing items 901-920 of 21282
-
ISO 3548-1
Abstract: This part of ISO 3548 specifies tolerances, design features, and test methods for thin-walled half bearings with integral flange up to an outside diameter of Do = 250 mm and without flange up to an ... -
ISO 28199-1 CORR 1
Abstract: This part of ISO 28199 defines terms relating to the evaluation of coating materials in research, development and production with regard to their suitability and safety for industrial processes and error analysis.
This ... -
ISO 14200
Abstract: This International Standard specifies the common implementation process for meteoroid and debris environment models for risk assessment of spacecraft and launch vehicle orbital stages. This International Standard gives ... -
ISO 2470-2
Abstract: This part of ISO 2470 specifies a method for measuring the D65 brightness of pulps, papers and boards.
This part of ISO 2470 is limited in its scope to white and near-white pulps, papers and boards, particularly those ... -
ISO 3951-2
Abstract: This part of ISO 3951 is primarily designed for use under the following conditions:
a) Where the inspection procedure is to be applied to a continuing series of lot s of discrete products all supplied ... -
ISO 10577
Abstract: This International Standard specifies the characteristics of rubber sheet floor coverings without backing.
This International Standard includes a classification system based on intensity of use, which shows where ... -
ISO DIS 16699
Abstract: This standard focuses on disposal of launch vehicle stages used during launch of spacecraft to be operated in space where the launch stages are left in orbit after the spacecraft are released.
End-of-mission disposal ... -
ISO 22938
Abstract: This International Standard defines the interchange of content/document management (CDM) data and all associated resources. -
ISO 15610
Abstract: This standard gives the necessary information to explain the requirements referenced in EN ISO 15607:2003 about the qualification of welding procedures based on tested consumables.
In addition, it gives the range of ...