درباره ما
ISO - International Organization for Standardization: Recent submissions
Now showing items 981-1000 of 21282
-
ISO FDIS 2538-2
Abstract: This part of ISO 2538 specifies methods for the dimensioning and tolerance of wedges
NOTE For simplicity, only truncated wedges have been represented in this part of ISO 2538; however, this document can be applied to ... -
ISO 26623-2
Abstract: This part of ISO 26623 specifies the dimensions for a polygonal taper interface with flange contact surface: polygon-receivers for automatic and manual tool exchange to be applied on machine tools (e.g. turning machines, ... -
ISO 10790
Abstract: This International Standard gives guidelines for the selection, installation, calibration, performance, and operation of Coriolis flowmeters for the measurement of mass flow and density. This International Standard also ... -
ISO 8565
Abstract: This International Standard establishes general requirements for stationary corrosion testing of metals and metallic and other inorganic coatings under atmospheric conditions carried out in the open air or under shelters. ... -
ISO 15701
Abstract: This International Standard specifies a method for assessing the propensity of dyes and pigments to migrate from leather to a synthetic substrate by determining the transfer of colour from the leather to white plasticized ... -
ISO ISO/IEC 24764 FDAM 1
Abstract: INTRODUCTION to Amendment 1
Amendment 1 of ISO/IEC 24764:2010 provides an introduction to the intermediate cabling subsystem and an explanatory annex for the combination of several permanent links to ... -
ISO 31000
Abstract: This International Standard provides principles and generic guidelines on risk management.
This International Standard can be used by any public, private or community enterprise, association, group or individual. ... -
ISO 7091
Abstract: This International Standard specifies the characteristics of normal-series, product-grade-C plain washers in the 100 HV hardness class and of nominal sizes (nominal thread diameters) ranging from 1,6 mm to 64 mm inclusive. ... -
ISO ISO/IEC 10918-1
Abstract: This CCITT Recommendation International Standard is applicable to continuous-tone - grayscale or colour - digital still image data. It is applicable to a wide range of applications which require use of compressed ... -
ISO TS 16976-2
Abstract: This part of ISO/TS 16976 is one part of a series of Technical Specifications that provide information on factors related to human anthropometry, physiology, ergonomics, and performance for the preparation of standards for ... -
ISO 10088
Abstract: This International Standard specifies the requirements for the design, materials, construction, installation and testing of permanently installed fuel systems as installed for internal combustion engines.
It applies ... -
ISO 3573
Abstract: This International Standard applies to hot-rolled carbon steel sheet of commercial and drawing qualities. Hot-rolled steel sheet is suitable for many applications where the presence of oxide or scale, or normal surface ... -
ISO 12619-3
Abstract: This part of ISO 12619 specifies tests and requirements for the pressure regulator, a compressed gaseous hydrogen (CGH2) and hydrogen/natural gas blends fuel system component intended for use on the typ JS of motor vehicles ... -
ISO 18932
Abstract: This International Standard provides specifications for adhesive mounting materials for use in attaching prints, including photographic, electrophotographic, electrostatic, thermal transfer or inkjet prints to mounting ...