Standard Method of Test for Mechanical Testing of Steel Products

Abstract

These test methods cover procedures and definitions for the mechanical testing of steel, stainless steels, and related alloys.

The various mechanical tests herein described are used to determine properties required in the product specifications.

Variations in testing methods are to be avoided and standard methods of testing are to be followed to obtain reproducible and comparable results.

In those cases in which the testing requirements for certain products are unique or at variance with these general procedures, the product specification testing requirements shall control.

The values stated in SI (MPa) units are to be regarded as the standard.

When this document is referenced in a metric product specification, the yield and tensile values may be determined in inch-pound (ksi) units then converted into SI (MPa) units.

The elongation determined in inch-pound gauge lengths of 2 or 8 in. may be reported in SI unit gauge lengths of 50 or 200 mm, respectively, as applicable.

Conversely, when this document is referenced in an inch-pound product specification, the yield and tensile values may be determined in SI units and then converted into inch-pound units.

The elongation determined in SI unit gauge lengths of 50 or 200 mm may be reported in inch-pound gauge lengths of 2 or 8 in., respectively, as applicable.

The specimen used to determine the original units must conform to the applicable tolerances of the original unit system given in the dimension table not that of the converted tolerance dimensions.

Note 1—This is due to the specimen SI dimensions and tolerances being hard conversions when this is not a dual standard.

The user is directed to Test Methods A1058 if the tests are required in SI units.

Attention is directed to R 18 when there may be a need for information on criteria for evaluation of testing laboratories.

This standard does not purport to address all of the safety concerns, if any, associated with its use.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.