Defence Standards: Recent submissions

Now showing items 61-80 of 43216

    • NASA-LLIS-0759 

      Type: standard
      Source: NASA - National Aeronautics and Space Administration (NASA):;2000
      Organization : NASA - National Aeronautics and Space Administration (NASA)
      Abstract: Practice:
      Critical design features that reduce joint rotation, improve seal features, provide close tolerances, provide for leak checks, and provide venting are used to improve the reliability of ...

    • NASA-LLIS-1485 

      Type: standard
      Source: NASA - National Aeronautics and Space Administration (NASA):;2004
      Organization : NASA - National Aeronautics and Space Administration (NASA)
      Abstract: Abstract:
      NASA elected at the end of MER Phase A to build a second Mars Exploration Rover at an estimated cost of $243 million. In addition to potentially doubling science return from Mars and mitigating ...
      Subject(s) : Flight Equipment , flight spares , Hardware , integration and test , Policy & Planning , Program and Project Management , Risk Management/Assessment , schedule constraints , schedule margin , Spacecraft , system testbed , Test & Verification , Test Article , test bed ,

    • MIL-HDBK-411B VOL I VALID NOTICE 1 

      Type: standard
      Source: ARMY - CR - US Army Communications Electronics Command:;2000
      Organization : ARMY - CR - US Army Communications Electronics Command

    • MSFC-PLAN-2889 REV A CHG NOTICE 1 

      Type: standard
      Source: MSFC - NASA - MSFC - Marshall Space Flight Center:;2001
      Organization : MSFC - NASA - MSFC - Marshall Space Flight Center
      Abstract: This document presents the Quality Plan to be implemented for the Dynamically-Controlled Protein Crystal Growth (DCPCG) hardware and software that is being developed by the University of Alabama in Birmingham (UAB) under ...

    • MIL-DTL-62011E 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;2009
      Organization : DLA - CC - DLA Land and Maritime
      Abstract: This specification covers electrically-operated 24-volt (V), direct current (dc), in-tank fuel pumps capable of delivering 200 gallons per hour (gph) with outlet pressure at 4 pounds per square inch gauge (psig) (see ...
      Subject(s) : Diesel , Flow , Gallons per hour , Gasoline , Motor , Pressure ,

    • MIL-PRF-19500/607B 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;2004
      Organization : DLA - CC - DLA Land and Maritime
      Abstract: This specification covers the performance requirements for N-channel, and P-channel, enhancement-mode, MOSFET, power transistor. Four levels of product assurance are provided for each device type as specified in MIL-PRF-19500, ...

    • MIL-DTL-15665/91 

      Type: standard
      Source: ARMY - IH - Institute of Heraldry:;1996
      Organization : ARMY - IH - Institute of Heraldry
      Abstract: This specification is approved for use by all Departments and Agencies of the Department of Defense.
      The requirements for acquiring the product described herein shall consist of this specification sheet and the issue ...

    • SMD-5962-95513 REV A 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;2010
      Organization : DLA - CC - DLA Land and Maritime
      Abstract: This drawing documents two product assurance class levels consisting of high reliability (device classes Q and M) and space application (device class V). A choice of case outlines and lead finishes are available and are ...

    • MIL-STD-1320 -165 NOTICE 1 

      Type: standard
      Source: NAVY - OS - Naval Surface Warfare Center (NSWCIHEODTD):;1976
      Organization : NAVY - OS - Naval Surface Warfare Center (NSWCIHEODTD)

    • NACA-TR-648 

      Type: standard
      Source: NASA - National Aeronautics and Space Administration (NASA):;1939
      Organization : NASA - National Aeronautics and Space Administration (NASA)
      Abstract: Equations and design charts are given for predicting the downwash angles and the wake characteristics for power-off conditions behind plain and flapped wings of the types used in modern design practice. The downwash charts ...
      Subject(s) : AERODYNAMIC , ANALYSIS , ANGLES , ASPECT , CHARTS , DESIGN , DISTRIBUTION , DOWNWASH , DRAG , ELLIPTICITY , FLAPS , FORCES , GEOMETRY , LIFT , LOAD , PREDICTION , PRESSURE , RATIO , SPAN , SWEPT , TECHNIQUES , WAKES , WING , WINGS ,

    • SMD-5962-97624 REV B 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;2009
      Organization : DLA - CC - DLA Land and Maritime
      Abstract: This drawing documents two product assurance class levels consisting of high reliability (device classes Q and M) and space application (device class V). A choice of case outlines and lead finishes are available and are ...

    • MIL-STD-902A 

      Type: standard
      Source: ARMY - GL - U.S. Army Natick Soldier Research, Development & Engineering Center:;1988
      Organization : ARMY - GL - U.S. Army Natick Soldier Research, Development & Engineering Center

    • NASA-LLIS-1859 

      Type: standard
      Source: NASA - National Aeronautics and Space Administration (NASA):;2008
      Organization : NASA - National Aeronautics and Space Administration (NASA)
      Abstract: Abstract:
      NASA subject experts can speed negotiating contract specifications because they know what is and is not the state-of-the-art. They can avoid including requirements that would delay delivery ...
      Subject(s) : Systems Engineering and Analysis. , Systems Engineering and Analysis.Level II/III requirements definition ,

    • MIL-DTL-41819/18E 

      Type: standard
      Source: ARMY - IH - Institute of Heraldry:;2013
      Organization : ARMY - IH - Institute of Heraldry

    • SMD-5962-95687 REV E 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;2013
      Organization : DLA - CC - DLA Land and Maritime
      Abstract: This drawing documents two product assurance class levels consisting of high reliability (device class Q) and space application (device class V). A choice of case outlines and lead finishes are available and are reflected ...

    • MIL-PRF-83446/23A 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;2006
      Organization : DLA - CC - DLA Land and Maritime

    • MIL-J-641/1D VALID NOTICE 1 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;1988
      Organization : DLA - CC - DLA Land and Maritime

    • SMD-5962-97577 REV A 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;2006
      Organization : DLA - CC - DLA Land and Maritime
      Abstract: This drawing documents two product assurance class levels consisting of high reliability (device classes Q and M) and space application (device class V). A choice of case outlines and lead finishes are available and are ...

    • A-A-55171C VALID NOTICE 1 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;2007
      Organization : DLA - CC - DLA Land and Maritime
      Abstract: This CID covers the general requirements for radio frequency interference (RFI) suppression power line filters. These filters consist of capacitors and inductors used in combination with each other and are provided with ...

    • MIL-PRF-83401/7E (1) 

      Type: standard
      Source: DLA - CC - DLA Land and Maritime:;2011
      Organization : DLA - CC - DLA Land and Maritime
      Abstract: This specification covers the associated requirements for style RZ070, 6 pin single-in-line package (SIP) resistor networks. This style is available in all characteristics and all resistance tolerances. This specification ...