Defence Standards: Recent submissions
Now showing items 981-1000 of 43216
-
A-A-59685
Abstract: This Commercial Item Description (CID) covers the performance requirements of a synthetic base hydrocarbon grease thickened with a lithium complex soap that is intended for application as a lubricant for sealed bearings ...Subject(s) : Electric motors , Grease , Grease , sealed ball and roller bearing , Sealed bearing , -
SMD-5962-90656
Abstract: This drawing forms a part of a one part - one part number documentation system (see 6.6 herein). Two product assurance classes consisting of military high reliability (device classes B, Q, and M) and space application ... -
A-A-55304
Abstract: This Commercial Item Description covers the requirements for a polyester/wool serge dress skirt. The skirt is intended to be worn by female personnel of the Department of Defense as part of the Army\'s Dress uniform. -
MIL-H-89201/1
Abstract: This specification defines detailed requirements for the Defense Mapping Agency's (DMA) Harbor, Approach, and Coastal Charts at scales of 1:25,000 and larger (HAC 1). Intended Use: Harbor and Approach and ...Subject(s) : Bathymetry , Charting , Defense Mapping Agency (DMA) , Hydrography , Marine , Maritime , MC&G (Mapping , Charting and Geodesy) , Nautical , Navigation , -
DSCC-DWG-93076 REV J
Abstract: This drawing describes the requirements for a 1 watt, fixed, surface mounted, wirewound, power type resistor.Intended Use: Surface mount resistors are used in electronic circuits where space is a major concern. -
COMDTINST 12351.1
Abstract: PURPOSE.
This Instruction sets policy governing the assignment of performance-based retention service credit in a civilian reduction-in-force (RIF). It establishes a Coast Guard-wide method for ... -
A-A-59125/26
Abstract: The General Services Administration has authorized the use of this commercial item description (CID) as a replacement for Class 43TB of MIL-T-55164/26 for all federal agencies.
The requirements for acquiring the product ... -
MIL-STD-1339C
Abstract: The purpose of this military standard is to standardize contractor-related fitting out procedures and to definitize contractor fitting out responsibilities.
This military standard prescribes shipbuilding contractor ...Subject(s) : Fitting out responsibilities , Outfitting procedures , -
MIL-C-22442/34A
Abstract: [A circled] Inactive for new design after 30 September 1991. No superseding specification.
This specification is approved for use by the Naval Air Systems Command, Department of the Navy, and is ... -
MIL-F-16377/26A
Abstract: This specification sheet is approved for use by the Naval Sea Systems Command and is available for use by all Departments and Agencies of the Department of Defense.
The complete requirements for acquiring the fixtures ... -
COMDTINST 5100.28A
Abstract: Purpose. The purpose of this directive is to implement federal law which assigns NTSB and FAA responsibility or interest in certain mishaps involving military aircraft. Because various agencies and departments ... -
DSCC-VID-V62/09608 REV A
Abstract: This drawing documents the general requirements of a high performance single bit dual supply bus transceiver with configurable voltage translation and 3-state outputs microcircuit, with an operating temperature range of ...

درباره ما