IEEE - The Institute of Electrical and Electronics Engineers, Inc.: Recent submissions

Now showing items 1041-1060 of 2832

    • IEEE Standard for Design and Verification of Low-Power, Energy-Aware Electronic Systems 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: A method is provided for specifying power intent for an electronic design, for use in verification of the structure and behavior of the design in the context of a given power management architecture, and for driving ...
      Subject(s) : corruption semantics , IEEE 1801â„¢ , interface specification , IP reuse , isolation , level-shifting , power-aware design , power domains , power intent , power modes , power states , progressive design refinement , retention , retention strategies , IEEE Standards , Power system management , Energy management , Design methodology , Low power electronics ,

    • IEEE Guide for the Application of Surge-Protective Components in Surge Protective Devices and Equipment Ports--Part 6 High Frequency Signal Isolation Transformers 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Surge protective components (SPCs) used in power and telecom surge protective devices (SPDs) and equipment ports are covered in the IEEE C62.42 guide series. The following are covered in this part of the series on ...
      Subject(s) : characteristics , common-mode surge , differential-mode surge , Ethernet , high frequency , IEEE C62.42.6 , isolation transformer , PoE , ratings , IEEE Standards , Surge protection , Power transformers , Ethernet ,

    • IEEE Recommended Practice for Seismic Design of Substations 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Seismic design recommendations for substations, including qualification of different equipment types are discussed. Design recommendations consist of seismic criteria, qualification methods and levels, structural capacities, ...
      Subject(s) : anchorage , conductor , electrical equipment , damping , dynamic analysis , IEEE 693(TM) , loads , projected performance , required response spectrum , seismic protective devices , seismic qualification , shake table , static coefficient analysis , support structure , suspended equipment , time history , IEEE Standards , Seismic measurements , Substations , Design methodology ,

    • ISO/IEC/IEEE Health informatics--Point-of-care medical device communication Part 10207: Domain Information and Service Model for Service-Oriented Point-of-Care Medical Device Communication 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Within the context of the ISO/IEEE 11073â„¢ family of standards for point-of-care medical device communication, a Participant Model derived from the ISO/IEEE11073-10201 Domain Information Model is provided in this standard. ...
      Subject(s) : alert systems , IEEE 11073-10207 , medical device communication , patient , point-of-care , remote control , service-oriented architecture , XML Schema , IEEE Standards , ISO Standards , IEC Standards , Point of care , Biomedical equipment , Service-oriented architecture , Patient monitoring , Remote control ,

    • ISO/IEEE International Standard - Health informatics--Personal health device communication - Part 10425: Device Specialization--Continuous Glucose Monitor (CGM) 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Within the context of the ISO/IEEE 11073 family of standards for device communication, a normative definition of the communication between continuous glucose monitor (CGM) devices and managers (e.g., cell phones, personal ...
      Subject(s) : continuous glucose monitor , IEEE 11073-10425 , medical device communication , personal health devices , IEEE Standards , ISO Standards , Biomedical equipment , Biomedical monitoring , Glucose , Diabetes ,

    • ISO/IEEE International Standard - Health informatics--Personal health device communication - Part 10419: Device Specialization--Insulin Pump 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Within the context of the ISO/IEEE 11073 family of standards for device communication, a normative definition of communication between personal telehealth insulin pump devices and compute engines (e.g., cell phones, personal ...
      Subject(s) : IEEE 11073-10419â„¢ , insulin pump , medical device communication , personal health devices , IEEE Standards , Medical devices , Pumps , Insulin , Biomedical monitoring , Biomedical measurements , Patient monitoring ,

    • IEEE Standard Terms for Reporting and Analyzing Outage Occurrences and Outage States of Electrical Transmission Facilities 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Terminology and indices for reporting and analyzing outage occurrences of transmission facilities are defined in this standard. Outage definitions and indices are given for two general types of facilities: units and ...
      Subject(s) : data , electricity transmission , exposure , failure , IEEE 859 , maintenance , outage , power systems , reliability , weather , IEEE Standards , Power outages , Power system reliability , Meterology , Power transmission , Failure analysis , Electricity ,

    • IEEE Guide for Application and Management of Stationary Batteries Used in Cycling Service 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Information on the differences between stationary standby and stationary cycling applications and appropriate battery management strategies in cycling operations is covered in this guide. While the primary emphasis is on ...
      Subject(s) : battery cycling , battery maintenance , battery operation , IEEE 1660â„¢ , standby battery , stationary battery , IEEE Standards , Batteries , Maintenance engineering , Lead acid batteries ,

    • IEEE Recommended Practice for Routing Packets in IEEE 802.15.4(TM) Dynamically Changing Wireless Networks - Amendment 1: Fully Defined Use of Addressing and Route Information Currently in IEEE Std 802.15.10 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This amendment to IEEE Std 802.15.10 fully defines how the addressing and route information (already defined in the recommended practice) are to be used by the routing modes (also currently defined in the recommended ...
      Subject(s) : amendment , discovery and addition of new nodes , IEEE 802.15.4 , IEEE 802.15.10 , IEEE 802.15.10a , dynamic route reconfiguration , frame forwarding , purging of inactive routes , real time link status information exchange , re-establishment of broken/lost routes , route establishment , single hop appearance at the networking layer (not breaking standard Layer 3 mechanisms) , support for broadcast , support for multicast , IEEE Standards , Local area networks , Metropolitan area networks , Information exchange , Packet switching , Real-time systems , Routing protocols ,

    • IEEE Recommended Practice for Inductive Coordination of Electric Supply and Communication Lines 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: The inductive environment that exists in the vicinity of electric power and wire-line telecommunications systems and the interfering effects that may be produced are addressed. An interface that permits either party, without ...
      Subject(s) : communication lines , electric supply , IEEE 776 , inductive coordination , IEEE Standards , Transmission lines , Electricity supply industry , Rail transportation , Power transmission lines ,

    • American National Standard Validation Methods for Radiated Emission Test Sites, 1 GHz to 18 GHz 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard specifies methods for the validation of test sites used for radiated emission measurements in the frequency range of 1 GHz to 18 GHz.
      Subject(s) : ANSI C63.25.1 , radiated emission test sites , site voltage standing-wave ratio , test site validation , ANSI Standards , Radiation monitoring , Voltage control , Frequency measurement ,

    • IEEE Recommended Practice for Conducting Short-Circuit Studies and Analysis of Industrial and Commercial Power Systems 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Activities related to short-circuit analysis, including design considerations for new systems, analytical studies for existing systems, as well as operational and model validation considerations for industrial and commercial ...
      Subject(s) : ac decrement , asymmetrical fault current , available fault current , bolted fault , breaking capacity , breaking duty , data collection , dc component , dc decrement , dc offset , device duty calculation , fault calculation , fault duty , IEEE 3002.3 , interrupting capacity , interrupting duty , making capacity , making duty , momentary capacity , momentary duty , short-circuit analysis , short-circuit current , short-circuit studies , short-circuit withstand , symmetrical component , symmetrical fault current , system modeling , system validation , X/R ratio , IEEE Standards , Industrial power systems , Computational modeling , Analytical models , Fault currents , Systems modeling , Short-circuit currents , Data collection ,

    • IEEE Recommended Practice for the Implementation of Inductive Coordination Mitigation Techniques and Application 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Guidance for controlling or modifying the inductive environment and the susceptibility of affected wire line telecommunications facilities in order to operate within the acceptable levels of steady-state or surge induced ...
      Subject(s) : coordination , coupling , harmonic , ICEP , IEEE 1137(TM) , impedance , inductive , influence , mitigation , mutual , noise , power , susceptibility , IEEE Standards , Impedance , Inductive power transmission , Noise measurement , Harmonic analysis ,

    • IEEE Guide for Development of Specifications for Turnkey Substation Projects 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Systematic methodology, guidelines and practices for developing turnkey substation specifications are provided in this guide. Guidance on engineering, procurement, construction, testing and commissioning, quality ...
      Subject(s) : design-build , EPC , IEEE 1267 , specification , specify , substation , turnkey , IEEE Standards , Turnkey project , Substations , Design methodology , Formal specifications ,

    • IEEE Standard for Adaptive Streaming 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard specifies the media presentation description (MPD) format and media segment format for dynamic and adaptive streaming over networks such as Hypertext Transfer Protocol (HTTP).
      Subject(s) : IEEE Standards , Adaptive systems , Media streaming , Media , Hypertext systems ,

    • American National Standard for Electromagnetic Compatibility--Radiated Emission Measurements in Electromagnetic Interference (EMI) Control—Calibration and Qualification of Antennas (9 kHz to 40 GHz) - Corrigendum 1 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Methods for determining antenna factors of antennas used for radiated emission measurements in electromagnetic interference (EMI) control from 9 kHz to 40 GHz are provided. Antennas included are linearly polarized antennas ...
      Subject(s) : ANSI C63.5 , antenna factors , equivalent capacitance substitution , linearly polarized antennas , near-free space , reference antenna method , standard antenna method , standard site method , standard transmit loop method , IEEE Standards , Electromagnetic compatibility , Transmitting antennas , Capacitance , Polarization , Radiation monitoring ,

    • IEEE Standard for Device Discovery, Connection Management, and Control Protocol for IEEE 1722(TM) Based Devices - Corrigendum 1:Technical and Editorial Corrections 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Technical and editorial corrections are provided by this corrigendum to IEEE Std 1722.1-2013.
      Subject(s) : AVDECC , bridged LAN , corrigendum , IEEE 61883 , IEEE 802.1 AVB protocols , IEEE 802.1AS , 802.1BA , 802.1Q , IEEE 1722 , IEEE 1722.1 , LAN , QoS , SMPTE ST 2022-6:2011 , time-sensitive media streaming , time-sensitive networking , time synchronization , TSN , IEEE Standards , Local area networks , Bridge circuits , Streaming media , Device drivers , Synchronization ,

    • IEEE Standard for Digital Media Content Description 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Tools for description of visual content, including still images and videos, are specified in this standard. Visual content description consists of visual features, text labels, and device information. This standard is ...
      Subject(s) : description , feature , IEEE 1857.6 , image , label , video , IEEE Standards , Visualization , Content management , Surveillance , Labeling , Video surveillance , Image capture , Content-based retrieval , Visual analytics ,

    • Health informatics--Point-of-care medical device communication - Part 20701: Service-Oriented Medical Device Exchange Architecture and Protocol Binding 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Within the context of the ISO/IEEE 11073 family of standards for point-of-care (PoC) medical device communication, an architecture for service-oriented distributed PoC medical devices and medical IT systems is defined. ...
      Subject(s) : alert systems , BICEPS , DiffServ , IEEE 11073-20701 , ISO/IEEE 11073 , MDPWS , medical device communication , NTP , patient , point-of-care , remote control , service-oriented architecture , IEEE Standards , Point of care , Medical devices , Patient monitoring , Service oriented architecture , ISO Standards , Information exchange ,

    • IEC/IEEE International Standard - Utility connections in port -- Part 1: High voltage shore connection (HVSC) systems -- General requirements 

      Type: Standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2019
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Subject(s) : IEEE Standards , IEC Standards , Power transmission , High-voltage techniques ,