IEEE - The Institute of Electrical and Electronics Engineers, Inc.: Recent submissions

Now showing items 1741-1760 of 2832

    • IEEE 1647 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2011
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard defines the e functional verification language. This standard aims to serve as an authoritative source for the definition of (a) syntax and semantics of e ...
      Subject(s) : assertion , concurrent programming , constraint , dynamic verification , functional coverage , functional verification , IEEE 1647 , simulation , temporal logic , test generation ,

    • IEEE 1215 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2013
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This guide provides general information on the application and operation of separable connectors. It is intended to be basic, and supplement the manufacturer's specific recommendations and established utility practices.

    • IEEE 433 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2009
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This document describes very low frequency (VLF) testing of ac electric machines. It covers acceptance testing of new machines in the factory or on-site after erection. Also covered is the routine maintenance testing of ...
      Subject(s) : ac electric machine testing , ac electric machines , diagnostic test , high-potential (hipotential) test , over potential test , proof testing , safety , very low frequency testing , VLF testing , withstand test ,

    • IEEE C37.09 ERTA 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2007
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.

    • IEEE 99 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2007
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Foreword
      (This Foreword is not a part of IEEE Std 99-1980, IEEE Recommended Practice for the Preparation of Test Procedures for the Thermal Evaluation of Insulation Systems for Electric Equipment.)
      The previous ...

    • IEEE 802.22.2 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2012
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This document recommends best engineering practices for the installation and deployment of IEEE 802.22 systems to help assure that such systems are correctly installed and deployed.
      Purpose
      This ...

    • IEEE 1658 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2011
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard defines terminology and test methods to clearly document prevalent world-wide terms used to describe and test digital-to-analog converters (DACs). It is restricted to monolithic, hybrid, and module DACs and ...
      Subject(s) : DAC , digital-to-analog converter , IEEE 1658 , SFDR , SNR , spectrum , test methods , test terminology ,

    • IEEE 1232.2 TRIAL USE 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;1998
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: The scope of this standard is to define the services needed to support AI-ESTATE. It provides a formal definition of the encapsulated services that an AI-ESTATE–conformant diagnostic reasoner shall provide to the ...

    • IEEE C37.41 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2008
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard specifies design test requirements for high-voltage (above 1000 V) fuses, distribution enclosed single-pole air switches, fuse disconnecting switches, and accessories for use on alternating-current distribution ...
      Subject(s) : distribution enclosed single-pole air switches , fuse accessories , fuse design tests , fuse disconnecting switches , high-voltage fuses ,

    • IEEE COMP 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;1990
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: The computer field is continuing to expand. New terms are being generated and new meanings are being adopted for existing terms. The IEEE Computer Dictionary project was undertaken to document this vocabulary. Its purpose ...

    • IEEE C62.37.1 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2012
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This application guide applies to thyristor surge protective components (SPCs) used in systems with voltages up to 1000 V rms or 1200 V dc. These components are designed to limit overvoltages and divert surge currents by ...

    • IEEE 802.21 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2008
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.

    • IEEE 802.3BM 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2015
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Physical Layer specifications and management parameters for 40 Gb/s operation over single-mode fiber (40GBASE-ER4) and for 100 Gb/s operation over multimode fiber (100GBASE-SR4) are added by this amendment. This amendment ...

    • IEEE 1521 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2003
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard allows the creation of instrumentation technology for consistent measurements of video-related time-interval errors (TIEs).
      Purpose
      This standard defines a set of measurements to ...
      Subject(s) : drift rate , frequency offset , jitter , timing interval error (TIE) , wander ,

    • IEEE C57.19.00 ERTA 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2010
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard applies to power apparatus bushings that have basic impulse insulation levels of 110 kV and above for use as components of oil-filled transformers and oil-filled reactors.
      This standard does not apply to ...
      Subject(s) : apparatus bushings , bushings , oil-filled reactors , oil-filled transformers ,

    • IEEE 802 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2007
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: 1.1 General
      Change the text of subclause 1.1 as shown below:
      This document serves as the foundation for the family of IEEE 802 standards published by IEEE for Local Area ...

    • IEEE C57.154 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2012
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard applies to all liquid-immersed distribution, power, and regulating transformers that are designed to operate at temperatures that exceed the normal thermal limits of IEEE Std C57.12.00TM 1 under continuous ...

    • IEEE 1017 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2013
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Procedures and test voltage values for acceptance and maintenance testing of ESP cable systems are presented. Installation and handling practices are also covered. This procedure applies to cable systems rated 3 kV and 5 ...

    • IEEE 62582-2 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2011
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Scope and object
      This part of IEC/IEEE 62582 contains methods for condition monitoring of organic and polymeric materials in instrumentation and control systems using the indenter modulus technique in ...

    • IEEE C95.2 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2005
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard defines the design of symbols denoting the incidence of radio-frequency (RF) electromagnetic energy in the frequency range from 3 kHz to 300 GHz. The standard also defines the use of these symbols in signs ...