Show simple item record

HOSE ASSEMBLY, POLYTETRAFLUOROETHYLENE, HIGH TEMPERATURE, MEDIUM PRESSURE, GENERAL SPECIFICATION FOR

contributor authorDLA - CC - DLA Land and Maritime
date accessioned2017-09-04T16:46:41Z
date available2017-09-04T16:46:41Z
date copyright08/05/2010
date issued2010
identifier otherWDASUCAAAAAAAAAA.pdf
identifier urihttps://yse.yabesh.ir/std/handle/yse/109971
description abstractThis specification contains the requirements for medium pressure, high temperature, polytetrafluoroethylene (PTFE) hose assemblies, reinforced with a corrosion-resistant steel (CRES) wire braid for use in fuel, lubricating oil, water-alcohol, hydraulics and pneumatic systems within the limits specified herein.Intended Use: The hose assembly covered by this specification is military unique to meet the requirements specified herein and in the applicable specification sheets. The hose qualified in accordance with MIL-DTL-27267 for field attachable fitting assemblies should be mated with either reusable fittings qualified in accordance with MIL-DTL-27272 or with permanent fittings to meet the requirements specified herein and in the applicable specification sheet. This hose assembly is a hydraulic or pneumatic conductor for a fluid at the operating pressure, specified in table III, even under extreme temperature conditions ranging from -65°F to 450°F (275°F for class 2). The hose assembly is intended for use in high-temperature fuel, lubricating oil, water-alcohol, chemical-fluid, hydraulic and pneumatic systems that allow some gaseous effusion through the hose wall. However, hose assembly used in hydraulic and pneumatic systems should not exceed the temperature limit of 400°F. Furthermore, it is recommended that this hose assembly should not be used in pneumatic storage system applications and in any applications that exceed the operating temperature range and pressure specified herein. Hose assembly sizes -20Z and -24Z should not be used in systems where the peak pressures are greater than 1000 psi (7MPa). Hose assembly size -3/-4 is not intended for use in aircraft hydraulic systems.
languageEnglish
titleMIL-DTL-25579G (1)num
titleHOSE ASSEMBLY, POLYTETRAFLUOROETHYLENE, HIGH TEMPERATURE, MEDIUM PRESSURE, GENERAL SPECIFICATION FORen
typestandard
page22
statusActive
treeDLA - CC - DLA Land and Maritime:;2010
contenttypefulltext
subject keywordsFire resistance
subject keywordsFuel resistance
subject keywordsHydraulic systems
subject keywordsLubricating oil
subject keywordsPneumatic systems
subject keywordsWater-alcohol


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record