Show simple item record

Relays, Electromagnetic, Established Reliability, General Specification fo

contributor authorDLA - CC - DLA Land and Maritime
date accessioned2017-09-04T16:50:25Z
date available2017-09-04T16:50:25Z
date copyright40896
date issued2011
identifier otherWNVCTEAAAAAAAAAA.pdf
identifier urihttps://yse.yabesh.ir/std/handle/yse/113984
description abstractThis specification covers the general requirements for electromagnetic, hermetically sealed relays for use in electronic and communication-type equipment (see 6.1). These relays are designed to operate over the full range from low level to power switching with contact ratings up to 5 amperes alternating current (ac) or direct current (dc). The failure rate level is established at a confidence level of 90 percent for qualification and 60 percent for maintenance of qualification based on 100,000 cycles at +125°C under the rated load conditions specified herein. CAUTION: The use of any coil voltage less than the rated coil voltage will compromise the operation of the relay. CAUTION: Pick-up, hold, and dropout voltages are for test purposes only and are not to be used as design criteria. For additional application and caution information, see 6.1. Intended Use: Relays conforming to this specification are intended for use in electronic and communication equipment. Their principal areas of application are for aircraft, missiles, spacecraft and ground-support electronic and communication equipment. This does not preclude the use of these relays in other military applications. CAUTION: The use of any coil voltage less than the rated coil voltage will compromise the operation of the relay. CAUTION: Transfer relay contacts are not to be used to ground load in one position and to 115-volt terminal in other position. Transfer relay contacts are not to be used to transfer load between phases, nor between unsynchronized ac sources. CAUTION: When latching relays are installed in equipment, the latch and reset coils should not be pulsed simultaneously. Coils should not be pulsed with less than the rated coil voltage and the pulse width should be a minimum of three times the specified operate time of the relay. If these conditions are not followed, it is possible for the relay to be in the magnetically neutral position.
languageEnglish
titleMIL-PRF-39016F VALID NOTICE 1num
titleRelays, Electromagnetic, Established Reliability, General Specification foen
typestandard
page1
statusActive
treeDLA - CC - DLA Land and Maritime:;2011
contenttypefulltext
subject keywordsAC coil
subject keywordsAll welded
subject keywordsCoil transient suppression
subject keywordsFull size crystal can
subject keywordsHalf size crystal can
subject keywordsHermetically sealed
subject keywordsLow level contact rating
subject keywordsMagnetic latch
subject keywordsReverse polarity sensitive
subject keywordsTO-5


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record