MIL-PRF-39016F (1)
RELAYS, ELECTROMAGNETIC, ESTABLISHED RELIABILITY, GENERAL SPECIFICATION FOR
| contributor author | DLA - CC - DLA Land and Maritime | |
| date accessioned | 2017-09-04T16:54:04Z | |
| date available | 2017-09-04T16:54:04Z | |
| date copyright | 09/26/2005 | |
| date issued | 2005 | |
| identifier other | WXKMIBAAAAAAAAAA.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/117489 | |
| description abstract | This specification covers the general requirements for electromagnetic, hermetically sealed relays for use in electronic and communication-type equipment (see 6.1). These relays are designed to operate over the full range from low level to power switching with contact ratings up to 5 amperes alternating current (ac) or direct current (dc). The failure rate level is established at a confidence level of 90 percent for qualification and 60 percent for maintenance of qualification based on 100,000 cycles at +125°C under the rated load conditions specified herein. CAUTION: The use of any coil voltage less than the rated coil voltage will compromise the operation of the relay. CAUTION: Pick-up, hold, and dropout voltages are for test purposes only and are not to be used as design criteria. For additional application and caution information, see 6.1. Intended Use: Relays conforming to this specification are intended for use in electronic and communication equipment. Their principal areas of application are for aircraft, missiles, spacecraft and ground-support electronic and communication equipment. This does not preclude the use of these relays in other military applications. CAUTION: The use of any coil voltage less than the rated coil voltage will compromise the operation of the relay. CAUTION: Transfer relay contacts are not to be used to ground load in one position and to 115-volt terminal in other position. Transfer relay contacts are not to be used to transfer load between phases, nor between unsynchronized ac sources. CAUTION: When latching relays are installed in equipment, the latch and reset coils should not be pulsed simultaneously. Coils should not be pulsed with less than the rated coil voltage and the pulse width should be a minimum of three times the specified operate time of the relay. If these conditions are not followed, it is possible for the relay to be in the magnetically neutral position. | |
| language | English | |
| title | MIL-PRF-39016F (1) | num |
| title | RELAYS, ELECTROMAGNETIC, ESTABLISHED RELIABILITY, GENERAL SPECIFICATION FOR | en |
| type | standard | |
| page | 49 | |
| status | Active | |
| tree | DLA - CC - DLA Land and Maritime:;2005 | |
| contenttype | fulltext | |
| subject keywords | AC coil | |
| subject keywords | All welded | |
| subject keywords | Coil transient suppression | |
| subject keywords | Full size crystal can | |
| subject keywords | Half size crystal can | |
| subject keywords | Hermetically sealed | |
| subject keywords | Low level contact rating | |
| subject keywords | Magnetic latch | |
| subject keywords | Reverse polarity sensitive | |
| subject keywords | TO-5 |

درباره ما