درباره ما
TIA - Telecommunications Industry Association: Recent submissions
Now showing items 21-40 of 1186
-
TIA TIA-102.BACE
Abstract: This specification is part of the "scope 2" ISSI work to add support for Consoles, Conventional, Packet Data, OTAR, and Supplementary Data to the ISSI. This specification covers console and fixed station support for ... -
TIA 252-A
Abstract: INTRODUCTION AND SCOPE
This standard applies to microwave relay communication systems. Usually these systems are multi-hop. They transmit intelligence initially derived from speech, telegraph, data, ... -
TIA TIA-455-6-B
Abstract: Intent.1
The intent of this test is to mechanically stress the interconnecting-device-to-fiber-optic-cable-joint in tension. The results of this test provide an indication as to the relative ... -
TIA TIA-455-89-B
Abstract: Introduction
This procedure describes a method for determining the elongation and tensile strength of optical fiber cable jackets.
Methods are included for both non-bonded and bonded jackets. Methods for jackets ...Subject(s) : jacket material , -
TIA TIA/EIA-102.BABB
Abstract: This document specifies the procedures to be employed to test that implementations of TIA-102.BABA compatible speech codecs comply with the standard. This speech codec is the Improved Multi-Band Excitation (IMBETM, ... -
TIA TIA-1048
Abstract: This part of IEC 62005 describes a common set of procedures for estimating the reliability of fibre optic connectors, splices, branching devices and other passive components. This part deals specifically with component ... -
TIA TIA-881
Abstract: OBJECTIVE
This purpose of this document is to specify the intersystem operations that enable a wireless system to provide enhanced location services1.
1. See TIA-843 for a description ... -
TIA J-STD-025-B-1
Abstract: This addendum only consists of additions to ANSI/J-STD-025-B adding MEID, as follows:
a. Page 12 Line 46: Section 3 -- Definitions and Acronyms – Add Mobile Equipment IDentifier (MEID).
b. Page 92 Line 10: ... -
TIA TIA-158
Abstract: INTRODUCTION
This Standard was prepared by Technical Specification Group C of the Third Generation Partnership Project 2 (3GPP2).This Standard presents recommendations for supporting a mobile station ... -
TIA TSB-102.CBBC
Abstract: This standard provides definition, methods of measurement, and performance standards for radio equipment used in the Private (Dispatch) Land Mobile Services that employ C4FM or CQPSK modulation, for transmission and reception ... -
TIA TIA-1144-A
Abstract: This document specifies the requirements for and operations of femtocells within cdma2000®1 networks from the perspective of the user(s) and/or the system operator.
The objective is to define and to ... -
TIA TIA/EIA-732-820
Abstract: Introduction
This Part provides the state transition tables for the user side and network side of Part 402 procedures.
CDPD MAC procedures are asymmetrical. This means that the behavior and procedures ... -
TIA TIA/EIA/IS-848
Abstract: INTRODUCTION
Premium Rate Charging (PRC), Freephone (FPH) and Advice Of Charging (AOC) are charging related services that provide a set of advanced wireless charging capabilities. Rejection of Undesired ... -
TIA TIA-4968-A
Abstract: This document defines radio interface support for USSD in cdma2000®1 Spread Spectrum Systems.
supplementary service data (USSD) allows the Mobile Station (MS) user and a PLMN operator defined application ... -
TIA TIA/EIA-732-409
Abstract: Introduction
This Part details definitions, methods of measurement and minimum performance requirements of 800 MHz Cellular Digital Packet Data (CDPD) Mobile End System (M-ES) transceivers. These ... -
TIA TIA-455-160-A
Abstract: Scope and object
This part of IEC 60793 provides a practical method for evaluating fibre performance in a defined environment.
The purpose of this standard is to determine the suitability of optical ... -
TIA TIA-613
Abstract: Section Abstracts
This standard is applicable to the interconnection of data terminal equipment (DTE) and data circuit-terminating equipment (DCE) employing serial binary data interchange with control ...