درباره ما
TIA - Telecommunications Industry Association: Recent submissions
Now showing items 901-920 of 1186
-
TIA TIA-1044
Abstract: The objective of these tests is to demonstrate mobile station or base station compliance to over-the-air messaging and protocol requirements in the cdma2000 family of standards, with emphasis on reference [1], indicated ... -
TIA TIA-1074
Abstract: The purpose of this document is to specify the modifications to [MAP] and [OTA] for OTA support of the MEID. -
TIA TIA-455-204-A
Abstract: This part of IEC 60793 describes three methods for determining and measuring the modal bandwidth of multimode optical fibres (see IEC 60793-2-10, IEC 60793-30 series and IEC 60793-40 series). The baseband frequency response ... -
TIA TIA-598-C
Abstract: This standard defines the recommended identification scheme or system for individual fibers, fiber units, and groups of fiber units within a cable structure. The methods contained herein may be used to identify and locate ...Subject(s) : color identification , fiber identification , identification scheme , -
TIA TIA-156-A
Abstract: The required specifications, test conditions and methods of measurement of RF Signal Boosters (commonly called BDA's) used in Land-Mobile Services (e.g. FCC Part 90 and similar harmonized services) are presented for ... -
TIA TIA-102.AABD-A
Abstract: APCO Project 25 digital radio systems will optionally support a trunking mode of operation. This document provides details of the procedures required such that, where systems are configured in the trunking mode, voice and ... -
TIA TIA-455-107-A
Abstract: This test procedure provides only a cumulative return loss for systems or links being tested. This procedure also provides a reflectance measurement for discrete components. If the reflectance for individual components in ... -
TIA TIA-102.BABA-1
Abstract: This document specifies the voice coding method for the Project 25 System and Standard Definition IS102 (originally published as a TSB). It describes the functional requirements for the transmission and reception of voice ... -
TIA TIA-455-135
Abstract: Introduction
Intent
The intent of this procedure is to determine the circular runout of the ferrule hole in the end of an optical fiber connector femile relative to the ferrule ... -
TIA TIA-902.BAAB-A
Abstract: The scope of this document is to define the physical layer (PHY) of the Scalable Adaptive Modulation (SAM) Wideband Air Interface (WAI). The WAI called Uw is the interface between the fixed network equipment (FNE) and a ... -
TIA TIA/EIA-578-B
Abstract: This standard contains protocols for use between a DTE and a Facsimile DCE. It includes automatic calling and answering.
This standard defines the commands that the DTE may issue to configure and control the DCE, and ... -
TIA TIA-455-14-A
Abstract: INTRODUCTION
Intent.1 The intent of this test is to determine the ability of fiber optic components (such as interconnecting devices) to withstand shocks such as those ... -
TIA TIA/EIA-793
Abstract: This Standard defines a model of the characteristics of the Public Switched Telephone Network (PSTN) in the continental United States of America which determine PCM modem transmission performance. It is intended to be the ... -
TIA TIA-4944
Abstract: Scope of This Document
These technical requirements form a compatibility standard for Air Interface Application Security services on cdma2000 high rate packet data systems. These requirements ... -
TIA TIA-136-350-C
Abstract: Purpose and Scope
This standard specifies Data-Service Control (DSC) for TDMA wire4 less systems. DSC uses standardized user-network commands and responses to access the following services and features: ... -
TIA TIA-102.AACA-1
Abstract: Introduction
This addendum specifies the general security requirements to be used when transmitting Type 3 Key Management Messages (KMMs) as defined in the Over The Air Rekeying (OTAR) Protocol document ...