درباره ما
Standard Test Method for Thermal Endurance of Flexible Sheet Materials Used for Electrical Insulation by the Curved Electrode Method
ASTM D1830-17
| contributor author | ASTM - ASTM International | |
| date accessioned | 2024-12-17T23:30:05Z | |
| date available | 2024-12-17T23:30:05Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | D1830-17r24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/337972 | |
| description abstract | 5.1 A major factor affecting the life of insulating materials is thermal degradation. Other factors, such as moisture and vibration, are able to cause failures after the material has been weakened by thermal degradation. 5.2 Electrical insulation is effective in electrical equipment only as long as it retains its physical and electrical integrity. Thermal degradation is able to be characterized by weight change, porosity, crazing, and generally a reduction in flexibility, and is usually accompanied by an ultimate reduction in dielectric breakdown voltage. | |
| language | English | |
| title | Standard Test Method for Thermal Endurance of Flexible Sheet Materials Used for Electrical Insulation by the Curved Electrode Method | en |
| title | ASTM D1830-17 | num |
| type | standard | |
| page | 5 | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method provides a procedure for evaluating thermal endurance of flexible sheet materials by determining dielectric breakdown voltage at room temperature after aging in air at selected elevated temperatures. Thermal endurance is expressed in terms of a temperature index. 1.2 This test method is applicable to such solid electrical insulating materials as coated fabrics, dielectric films, composite laminates, and other materials where retention of flexibility after heat aging is of major importance (see Note 4). 1.3 This test method is not intended for the evaluation of rigid laminate materials nor for the determination of thermal endurance of those materials which are not expected or required to retain flexibility in actual service. 1.4 The values stated in acceptable metric units are to be regarded as the standard. The values in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 10.1. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D1830-17R24 |
