درباره ما
Standard Specification for Emulsified Coal-Tar Pitch (Mineral Colloid Type)
ASTM D3320/D3320M-18
| contributor author | ASTM - ASTM International | |
| date accessioned | 2024-12-17T23:30:12Z | |
| date available | 2024-12-17T23:30:12Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | D3320_D3320M-18r24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/337990 | |
| language | English | |
| title | Standard Specification for Emulsified Coal-Tar Pitch (Mineral Colloid Type) | en |
| title | ASTM D3320/D3320M-18 | num |
| type | standard | |
| page | 3 | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers mineral-colloid-stabilized, emulsified coal-tar pitch suitable for use as a weather-protective and aliphatic-solvent resistant coating over bituminous pavements of airports, parking areas, and driveways. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3 The following precautionary caveat pertains only to the test method portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D3320_D3320M-18R24 |
