درباره ما
Standard Test Methods for Measurement of Torque Retention for Packages with Continuous Thread Closures Using Non-Automated (Manual) Torque Testing Equipment
ASTM D2063/D2063M-24
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:58:10Z | |
| date available | 2025-09-30T17:58:10Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d2063_d2063m-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/340603 | |
| description abstract | 5.1 This test method allows for the measurement of the torque retention properties of container/continuous thread closure systems of various designs, materials, manufacture, and is suitable for packaging development and engineering evaluation. 5.2 This test method can be used for the evaluation of container/continuous thread closure systems under controlled conditions (where the application torque is known and the applied downward force to the closure is zero). 5.3 This test method measures torque retention properties of container/continuous thread closure systems with the use of a non-automated, spring torque-meter (with either a dial indicator or a digital readout) or a torque wrench. | |
| language | English | |
| title | Standard Test Methods for Measurement of Torque Retention for Packages with Continuous Thread Closures Using Non-Automated (Manual) Torque Testing Equipment | en |
| title | ASTM D2063/D2063M-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This is a quantitative method that measures removal torque of continuous thread closures on containers, with matching finishes for predetermined environmental conditions over time. The range of values that can be measured are limited to the equipment used. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Note 1: The SI unit system is the recommended system. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D2063_D2063M-24 |
