درباره ما
Standard Test Method for Mechanical Size Analysis of Extracted Aggregate
ASTM D5444-24
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:59:03Z | |
| date available | 2025-09-30T17:59:03Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d5444-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/340834 | |
| description abstract | 3.1 This test method is used to determine the grading of aggregates extracted from asphalt mixtures. The results are used to determine compliance of the particle size distribution with applicable specifications requirements, and to provide necessary data for control of the production of various aggregates to be used in asphalt mixtures. Note 1: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors. | |
| language | English | |
| title | Standard Test Method for Mechanical Size Analysis of Extracted Aggregate | en |
| title | ASTM D5444-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method covers a procedure for determination of the particle size distribution of fine and coarse aggregates extracted from asphalt mixtures using sieves with square openings. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D5444-24 |
