درباره ما
Standard Specification for Benzene for Use with Zeolite Based Catalysts
ASTM D7124-24
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:59:38Z | |
| date available | 2025-09-30T17:59:38Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d7124-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/340978 | |
| description abstract | This specification covers benzene for use with zeolite based catalysts. Tests shall be performed to determine the property requirements of benzene in accordance to the following test methods: benzene weight percentage; sulfur mass; thiophene mass; toluene mass; nonaromatic hydrocarbons weight percentage; nitrogen mass; acid wash color; bromine index, water, and appearance. | |
| language | English | |
| title | Standard Specification for Benzene for Use with Zeolite Based Catalysts | en |
| title | ASTM D7124-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers benzene for use with zeolite based catalysts. 1.2 The following applies to all specified limits in this specification: for purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29. 1.3 Consult current OSHA regulations, supplier’s Safety Data Sheets, and local regulations for all materials used in this specification. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D7124-24 |
