درباره ما
Standard Test Method for Brine Saturation Value of Cured (Salt-Preserved) Hides and Skins
ASTM D7476-08
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:03:15Z | |
| date available | 2025-09-30T18:03:15Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d7476-08r24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341896 | |
| description abstract | 5.1 This test method is intended to evaluate whether sufficient salt (NaCl) has been retained by the hides or skins to slow down degradation by bacterial (enzymatic) action, and to slow down autolysis by inherent enzymatic action, until they are preserved by a tanning process. Note 2: Osmosis occurs during brine curing because moisture is drawn out by salt through the epidermis.4 Low moisture (< 40 %) in the hides does not necessarily indicate poor cure. A hide may have low moisture due to osmosis; to increased fat content; or to drying out conditions. In all instances the hides would still show adequate cure if the moisture was saturated to approximately 85 % salt, because the ash: moisture ratio would be adequate. | |
| language | English | |
| title | Standard Test Method for Brine Saturation Value of Cured (Salt-Preserved) Hides and Skins | en |
| title | ASTM D7476-08 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method covers the estimation of degree of saturation of the brine content of cured (salt-preserved) hides and skins containing 40 % or more moisture. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D7476-08R24 |
