درباره ما
Standard Specification for Electrolytic Copper Cathode
ASTM B115-24
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:06:04Z | |
| date available | 2025-09-30T18:06:04Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | b0115-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342334 | |
| description abstract | 13.1 Calculated values shall be rounded to the desired number of places as directed in Practice E29. | |
| language | English | |
| title | Standard Specification for Electrolytic Copper Cathode | en |
| title | ASTM B115-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers the requirements for electrolytic copper cathode; electrorefined and electrowon. 1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Note 1: Cathode produced to this specification corresponds to the designation “Cath” as defined in Classification B224 and may be used to produce all other coppers listed in Classification B224 that are normally produced from “Cath” copper. Note 2: Grade 1 cathode conforms to the chemical compositional requirements of Copper UNS No. C11040, except for oxygen, and is suitable for the manufacture of wire rod as designated in Specification B49. 1.3 The following hazard caveat applies to the test methods described in Annex A2 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/B0115-24 |
