درباره ما
Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating
ASTM B481-24
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:06:11Z | |
| date available | 2025-09-30T18:06:11Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | b0481-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342355 | |
| description abstract | 3.1 Electroplated metals are used on titanium to enhance and improve its surface characteristics, such as, but not limited to; hardness, anti-galling, wear resistance and corrosion resistance. Effectively preparing titanium surfaces prior to metal plating is especially challenging due to the tenacity of titanium’s oxide film. Proper surface preparation is critical to activating titanium and achieving optimum plating results and coating performance. 3.2 This practice outlines surface preparation procedures required to produce satisfactory coatings on titanium alloys. | |
| language | English | |
| title | Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating | en |
| title | ASTM B481-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This practice describes processes that have been found to be successful in producing adherent electrodeposits of good quality on titanium and certain titanium alloys. Not all of the processes that have been reported as successful are described, but rather three basic ones that have had the widest use. A rather complete listing of the published work on electroplating on titanium is given in the list of references which appear at the end of this practice. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 4.1. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/B0481-24 |
