درباره ما
Standard Specification for Nickel-Molybdenum-Chromium-Iron Alloys Bar or Rod
ASTM B573-24
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:06:15Z | |
| date available | 2025-09-30T18:06:15Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | b0573-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342365 | |
| description abstract | This specification covers rods of nickel-molybdenum-chromium-iron alloys with UNS Nos. N10003 and N10242 for use in general corrosive service. Specimens shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (diameter, length, out-of-roundness, weight, and straightness), mechanical (tensile and yield strengths, and elongation), and chemical composition requirements. | |
| language | English | |
| title | Standard Specification for Nickel-Molybdenum-Chromium-Iron Alloys Bar or Rod | en |
| title | ASTM B573-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification2 covers nickel-molybdenum-chromium-iron alloys in the form of bar or rod. The alloys are typically for general corrosive service but not limited to this usage. 1.2 Alloys that can currently be certified to this specification are UNS N10003 and UNS N10242. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/B0573-24 |
