درباره ما
Standard Test Method for Hydrostatic Pressure Resistance of a Liquid-Applied Waterproofing Membrane
ASTM C1306/C1306M-24
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:07:30Z | |
| date available | 2025-09-30T18:07:30Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | c1306_c1306m-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342544 | |
| description abstract | 5.1 This test method is used as a screening tool to determine the hydrostatic pressure to which a liquid-applied waterproofing membrane may be subjected without failing when stretched over a crack in the substrate. This test method discriminates between a membrane that is very resistant to hydrostatic pressure and one that is not. Because of the variability inherent in this test method, it is not recommended that this test method be used to set a numerical standard for hydrostatic pressure resistance. No prediction of durability at lower hydrostatic pressures can be made when using the results of this test method. | |
| language | English | |
| title | Standard Test Method for Hydrostatic Pressure Resistance of a Liquid-Applied Waterproofing Membrane | en |
| title | ASTM C1306/C1306M-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method describes a laboratory procedure for determining the resistance of a waterproofing membrane to hydrostatic pressure. 1.2 The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations. 1.3 There are no ISO standards similar or equivalent to this ASTM standard. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/C1306_C1306M-24 |
