درباره ما
Standard Specification for Copper-Clad Aluminum Wire
ASTM B566-04a
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T19:18:55Z | |
| date available | 2025-09-30T19:18:55Z | |
| date copyright | 2025 | |
| date issued | 2025 | |
| identifier other | b0566-04ar25.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342781 | |
| description abstract | This specification covers bare round copper-clad aluminum wire for electrical applications. Four classes of copper-clad aluminum wire are covered such as Class 10A, Class 15A, Class 10H, Class 15H. The wire shall consist of a core of aluminum with a continuous outer cladding of copper throughly bonded to the core throughout and shall be of such quality as to meet the requirements of this specification. The copper-clad aluminum wire shall conform to the tensile strength and elongation requirements. The electrical resistivity shall be measured. The copper-clad aluminum wire, when tested shall be free from seams or splits. They shall be free from cladding delamination. The finished wire shall contain no joints or splices. The density of the wire shall be taken for calculating mass/unit length, cross section and so forth. | |
| language | English | |
| title | Standard Specification for Copper-Clad Aluminum Wire | en |
| title | ASTM B566-04a | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2025 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers bare round copper-clad aluminum wire for electrical applications. 1.2 Four classes of copper-clad aluminum wire are covered as follows: Class 10A—Nominal 10 volume % copper, annealed, Class 15A—Nominal 15 volume % copper, annealed, Class 10H—Nominal 10 volume % copper, hard-drawn, Class 15H—Nominal 15 volume % copper, hard-drawn. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3.1 Exception—The values stated in SI units for resistivity and density are to be regarded as standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/B0566-04AR25 |
