درباره ما
ARMY - AT - Tank-Automotive and Armaments Command: Recent submissions
Now showing items 821-832 of 832
-
A-A-52417A
Abstract: This CID covers the requirements for nickel-cadmium storage batteries primarily for service in military vehicles, starting of missile ground power equipment, radio operation, and as a source of electrical energy for operating ... -
-
MIL-DTL-45859D VALID NOTICE 1
Abstract: This specification covers a pneumatic pop-valve-test bench assembly for testing air-compressor components at pressures up to 6000 pounds per square inch gage (psig). Intended Use: The bench assembly covered ...Subject(s) : Air compressor , Compressor components , Gages , Hoses , Pneumatic , -
MIL-DTL-62421A
Abstract: This specification covers the system and acceptance requirements for a Digital Electronic Control Unit (DECU), herein referred to as the "assembly". The assembly provides fuel handling and vehicle interface capabilities ...Subject(s) : AGT 1500 , Engine controller , Gas turbine engine , -
MIL-HDBK-508 VALID NOTICE 1
Abstract: This standard covers the selection and installation of wiring and wiring devices used in combat and tactical vehicles.
This standard establishes design requirements for wiring combat and tactical vehicles. Although ...Subject(s) : Cable , Cable assembly , Wire , Wiring device , Wiring harness , -
MIL-DTL-62013E
Abstract: This specification covers two types of unarmored full-tracked, diesel powered vehicles. The M730A1 vehicle is designed for cross country and amphibious operation as a guided missile carrier. The M548A1 vehicle is for cross ...Subject(s) : Amphibious , Cab , Diesel , Hull , Suspension , Transmission , -
A-A-52428A
Abstract: This CID covers a clearance indicating reflector assembly, also referred to herein as reflector, which is comprised of a red or amber reflecting element (lens), mounted in a one or two piece metal flanged housing (see ...