Now showing items 1-20 of 126

      • MIL-H-19749 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1956
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers one size and type of sheet metal label holder for mailbag racks made of steel pipe.
      • LLL-T-431B 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1959
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification was approved by the Commissioner, Federal Supply Service. General Services Administration, for the use of all Federal agencies.
      • LLL-L-354C 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1967
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers desk and table top linoleum. Intended Use: The linoleum is intended for desk tops and table tops and under no circumstances shall be used as floor covering.
      • LLL-L-354C INT AMD 1 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1968
        Organization : NAVY - YD - Naval Facilities Engineering Command
      • UU-B-790A 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1968
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers building papers composed predominantly of sulphate pulp fibers. Intended Use: The paper is intended for use in waterproofing, and as a vapor barrier, flashing, or similar protection. ...
      • MIL-S-27624B 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1974
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers one type of explosion-proof toggle switch designed for single pole, single throw operation in class 1, groups C and D hazardous locations, as defined by the NFPA No. 70, National Electrical Code. ...
      • SS-C-153C 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1974
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers bituminous plastic cement for trowel or knife application. Intended Use: The cement covered by this specification is intended for use in the construction and repair of bituminous ...
      • TT-C-492C 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1974
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers a compound applied by brush or spray to provide antisweat protection on surfaces subject to condensation. Intended Use: The coating compound is intended for application on surfaces ...
      • UU-B-790A INT AMD 1 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1976
        Organization : NAVY - YD - Naval Facilities Engineering Command
      • TT-C-492C (1) 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1977
        Organization : NAVY - YD - Naval Facilities Engineering Command
      • SS-P-381B 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1979
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers reinforced concrete steel cylinder pipe in sizes from 10 inches to 42 inches (see 6.2 and 6.5). Intended Use: The pipe covered by this specification is intended for ...
      • WW-P-541E 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1980
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers the general requirements for plumbing fixtures. Specific requirements are covered by the applicable specification sheet (see 6.3). Intended Use: Most plumbing fixtures are ...
      • W-C-571C 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1981
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers conduit, asbestos-cement or fire clay cement, and fittings of equivalent material for use in the installation of electrical wires and cables, underground burial. Intended Use: The ...
      • MIL-P-23857B 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1982
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers two sizes of pumping assemblies designed for bulk transfer of heated asphalt in a mobile, continuous-mix asphalt plant. The pumping assemblies consist of a jacketed, positive-displacement, rotary ...
      • MIL-C-23880D 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1983
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers electrically heated, pass-through, and reach-in stationary food warming cabinets. Intended Use: Stationary food-warming cabinets covered by this specification are intended for use ...
      • OO-S-870E 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1984
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers gasoline, diesel, liquified petroleum-gas (LPG) engine powered, and battery powered, commercial, self-propelled, rider operated, industrial type sweepers equipped with a vacuum dust control system ...
      • MIL-T-82049C 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1984
        Organization : NAVY - YD - Naval Facilities Engineering Command
      • OO-S-873C 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1984
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This specification covers gasoline or diesel-engine powered, self-propelled, rider operated, industrial type sweepers equipped with a vacuum type dust control system and hopper capacity to collect and transport sweepings ...
      • MIL-C-29240 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1985
        Organization : NAVY - YD - Naval Facilities Engineering Command
        Abstract: This performance specification covers modular, moveable casework configurations for hospital laboratories and pharmacies. Intended Use: The movable modular casework and variants are for use in laboratories ...
      • MIL-M-29241 

        Type: standard
        Source: NAVY - YD - Naval Facilities Engineering Command:;1985
        Organization : NAVY - YD - Naval Facilities Engineering Command