Show simple item record

Transformers Pad-Mounted, Compartmental-Type, Self-Cooled, Single-Phase Distribution Transformers with Separable Insulated High-Voltage Connectors; High Voltage, 34 500 GrdY/19 920 Volts and Below; Low Voltage, 240/120 Volts; 167 kVA and Smaller Requirements - Replaces NEMA C57.12.25-1990

contributor authorIEEE - The Institute of Electrical and Electronics Engineers, Inc.
date accessioned2017-09-04T15:09:02Z
date available2017-09-04T15:09:02Z
date copyright01/01/1990
date issued1990
identifier otherLMSKCBAAAAAAAAAA.pdf
identifier urihttps://yse.yabesh.ir/std/handle/yse/7004
description abstractForeward
Accredited Standards Committee on Transformers, Regulators, and Reactors, C57, has for many years been developing and correlating standards on transformers and regulators. The data used in this work have been gathered from many sources, including the standards of the Institute of Electrical and Electronics Engineers and the National Electrical Manufacturers Association, reports of committees of the Edison Electric Institute, and others.
This standard was prepared by the Subcommittee on Distribution Transformers, Overhead and Pad-Mounted, C57.12.2.
Suggestions for improvement of this standard will be welcome. They should be sent to the National Electrical Manufacturers Association, 2101 L Street, NW, Washington, DC 20037.
Scope
This standard is intended for use as a basis for determining performance, interchangeability, and safety of the equipment covered, and to assist in the proper selection of such equipment.
This standard covers certain electrical, dimensional, and mechanical characteristics, and takes into consideration certain safety features of single-phase, 60-Hz, mineral-oil-immersed, self-cooled, pad-mounted, compartmental-type distribution transformers with separable insulated high-voltage connectors. These transformers are rated 167 kVA and smaller, with high voltages of 34500 GrdY/19 920 volts and below for operation between one phase and grounded neutral, and low voltages of 240/120 volts. These transformers are generally used for step-down purposes from an underground primary cable supply.
NOTE - Refer to latest federal regulations concerning PCB contamination in transformers.
This standard covers two connector and terminal arrangements for loop feed systems. Either Type 1 (see Figure 1) or Type 2 (see Figure 2) arrangements shall be specified.
This standard does not cover the electrical and mechanical requirements of any accessory devices that may be supplied with the transformer.
languageEnglish
titleIEEE C57.12.25num
titleTransformers Pad-Mounted, Compartmental-Type, Self-Cooled, Single-Phase Distribution Transformers with Separable Insulated High-Voltage Connectors; High Voltage, 34 500 GrdY/19 920 Volts and Below; Low Voltage, 240/120 Volts; 167 kVA and Smaller Requirements - Replaces NEMA C57.12.25-1990en
typestandard
page19
statusActive
treeIEEE - The Institute of Electrical and Electronics Engineers, Inc.:;1990
contenttypefulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record