MIL-DTL-26482H (2)
CONNECTORS, ELECTRICAL, (CIRCULAR, MINIATURE, QUICK DISCONNECT, ENVIRONMENT RESISTING), RECEPTACLES AND PLUGS, GENERAL SPECIFICATION FOR
| contributor author | DLA - CC - DLA Land and Maritime | |
| date accessioned | 2017-09-04T16:11:06Z | |
| date available | 2017-09-04T16:11:06Z | |
| date copyright | 06/21/2013 | |
| date issued | 2013 | |
| identifier other | SLFLFFAAAAAAAAAA.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/74324 | |
| description abstract | This specification covers the general requirements for two series of environment resisting, quick disconnect, miniature, circular electrical connectors (and accessories). Each series includes hermetic receptacles. The two series of connectors are intermateable when using power contacts and are not intermateable when using shielded contacts. When intermated, the minimum performance requirement for series 1 type connectors will be met.Intended Use: The various classes and types of connectors are intended for application as follows: a. Classes E, F, J, and P connectors are intended for use in environment-resisting applications where the operating temperature range of -55º to 125ºC (-67º to 257ºF) is experienced. Crimp contact connectors have the additional advantage of possessing removable crimp-type contacts. Class J connectors are intended for use with light-weight, single-jacketed cable. b. Class H receptacles are intended for use in applications wherein pressures must be contained by the connectors across the walls or panels on which they are mounted. c. Crimp contact connectors should have contacts installed in all positions when the connector is wired. Sealing plugs should be installed in the grommet holes when no wire is attached to the contact in grommet sealed connectors. d. The potting form should remain with the connector after potting. e. Counterpart solder and crimp contact connectors are intended to the intermateable. Moisture resistance capability is then reduced to that of the solder contact connector. f. If air leakage requirements are critical, a resilient insert, solder contact receptacle, a through bulkhead receptacle, or class H receptacle should be used, or the connector should be potted. g. For finished wire diameters less than specified in table II, shrink-fit sleeving should be used over the wire. h. Where two or more wires are used in a solder cup or wire barrel, grommet sealing is not obtainable. Wires should be potted if sealing is required. i. Connectors are available with finishes D, T, W and K for corrosion protection. | |
| language | English | |
| title | MIL-DTL-26482H (2) | num |
| title | CONNECTORS, ELECTRICAL, (CIRCULAR, MINIATURE, QUICK DISCONNECT, ENVIRONMENT RESISTING), RECEPTACLES AND PLUGS, GENERAL SPECIFICATION FOR | en |
| type | standard | |
| page | 104 | |
| status | Active | |
| tree | DLA - CC - DLA Land and Maritime:;2013 | |
| contenttype | fulltext |

درباره ما