Show simple item record

RELAYS, ELECTROMAGNETIC, ESTABLISHED RELIABILITY, 25 AMPERES AND BELOW, GENERAL SPECIFICATION FOR

contributor authorDLA - CC - DLA Land and Maritime
date accessioned2017-09-04T16:12:44Z
date available2017-09-04T16:12:44Z
date copyright01/02/2013
date issued2013
identifier otherBJSOBFAAAAAAAAAA.pdf
identifier urihttps://yse.yabesh.ir/std/handle/yse/75989
description abstractThis specification covers the general requirements for electromagnetic, hermetically sealed relays for use in aircraft, missile, spacecraft, ship, and other primary vehicles or in ground support equipment (see 6.1). These relays are designed to operate over the full range from low level to power switching with contact ratings up to 25 amperes alternating current (ac) or direct current (dc). Specification sheets (see 3.1) specifying requirements for 25 ampere relays are for relays that have a maximum load rating of 25 amperes for resistive load only. All other load ratings (motor, inductive, lamp) are less than 25 amperes. The failure rate (FR) level is established at a confidence level of 90 percent for qualification and 60 percent for maintenance of qualification based on 100,000 cycles at +125°C under the rated load conditions specified herein. For application and caution informationIntended Use: Relays conforming to this specification are intended for use in electronic and communication equipment. Their principal areas of application are for aircraft, missiles, spacecraft, and ground-support electronic and communication equipment. This does not preclude the use of these relays in other military applications. CAUTION: The use of any coil voltage less than the rated coil voltage will compromise the operation of the relay. CAUTION: An external single diode parallel to the relay coil may effect the characteristic of the relay, and reduce the required life significantly. CAUTION: Transfer relay contacts should not be used to ground load in one position and to 115 volt terminal in other position. Transfer relay contacts should not be used to transfer load between phases, nor between unsynchronized ac sources. CAUTION: When latching relays are installed in equipment, the latch and reset coils should not be pulsed simultaneously. Coils should not be pulsed with less than the nominal coil voltage and the pulse width should be a minimum of three times the specified operate time of the relay. If these conditions are not followed, it is possible for the relay to be in the magnetically neutral position. CAUTION: High in-rush currents caused by capacitive, inductive, motor, and lamp loads, can erode or weld contacts reducing life leading to premature relay failure. CAUTION: Failure rate level is determined under the life tests as specified in this specification. The failure rate may not be applicable under your application's load or environmental conditions. Misapplication is one of the major causes of relay failures, users are cautioned against using a relay in an application for which it is not rated. Users are advised to contact the qualifying activity for assistance with application problems. A helpful reference is the Engineers' Relay Handbook available from the National Association of Relay Manufacturers, 2500 Wilson Boulevard, Arlington, VA 22201, (703) 907-8025.
languageEnglish
titleMIL-PRF-83536Dnum
titleRELAYS, ELECTROMAGNETIC, ESTABLISHED RELIABILITY, 25 AMPERES AND BELOW, GENERAL SPECIFICATION FORen
typestandard
page50
statusActive
treeDLA - CC - DLA Land and Maritime:;2013
contenttypefulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record