DLA - CC - DLA Land and Maritime: Recent submissions
Now showing items 5081-5100 of 11453
-
MIL-M-38510/341F
Abstract: This specification covers the detail requirements for monolithic silicon, Advanced Schottky TTL, flip flop microcircuits. Two product assurance classes and a choice of case outlines/lead finish are provided and are reflected ... -
MIL-J-641/21A
Abstract: This specification is approved for use by all Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and the issue ... -
DSCC-VID-V62/03627 REV A
Abstract: This drawing documents the general requirements of an OHCI-Lynx PCI-Based IEEE 1394 host controller microcircuit, with an operating temperature range of -40°C to +110°C. -
MIL-DTL-38159C
Abstract: This specification covers the requirements for molded rubber male and female connectors for 480/277 volt ramp power (see 6.4.2, 6.4.4, and 6.4.9) for use in non-hazardous and hazardous (classified) locations. ...Subject(s) : Female receptacle , Hazardous , Male receptacle , Non-hazardous , Ramp outlet , Wall-mounted outlet , -
SMD-5962-96525 REV H
Abstract: This drawing documents two product assurance class levels consisting of high reliability (device class Q) and space application (device class V). A choice of case outlines and lead finishes are available and are reflected ... -
SMD-5962-94707 REV B
Abstract: This drawing documents two product assurance class levels consisting of high reliability (device classes Q and M) and space application (device class V). A choice of case outlines and lead finishes are available and are ... -
DESC-DWG-89089 REV C
Abstract: This drawing and MIL-PRF-55681 describe the requirements for high voltage, ceramic, chip capacitors.Intended Use: Capacitors conforming to this drawing are intended for use when military specifications do not ... -
SMD-5962-85517 REV B
Abstract: This drawing describes device requirements for MIL-STD-883 compliant, non-JAN class level B microcircuits in accordance with MIL-PRF-38535, appendix A.Intended Use: Microcircuits conforming to this drawing ... -
DESC-DWG-94019 REV H
Abstract: This drawing describes the requirements for a 0.100 by 0.100 chip resistor, which is resistant to the degrading effects of moisture while under power.Intended Use: Chip resistors are intended for use in thick ... -
DSCC-DWG-87055 REV F
Abstract: This drawing describes the requirements for a family of circuit breakers with illuminated handles for use in overcurrent protection.Intended Use: Devices conforming to this drawing are intended for use when ...

درباره ما