DLA - CC - DLA Land and Maritime: Recent submissions
Now showing items 7741-7760 of 11453
-
MIL-M-38510/751B VALID NOTICE 1
Abstract: This specification covers the detail requirements for monolithic silicon, advanced CMOS, logic microcircuits. Two product assurance classes and a choice of case outlines, lead finishes, and radiation hardness assurance ... -
DSCC-DWG-04049 REV D
Abstract: This drawing covers the performance characteristics for finished cables. The component wires are covered by DSCC drawings 04034 through 04048. These cables are intended for signal and power applications with environmental ... -
DSCC-DWG-83023 REV J
Abstract: This drawing describes the requirements for a family of plastic retainer—ejectors intended for use with printed circuit boards and circuit card assemblies in moderate shock and vibration environments.Intended ... -
DSCC-VID-V62/03620 REV A
Abstract: This drawing documents the general requirements of a high performance 36-bit bus transceiver with three-state outputs microcircuit, with an operating temperature range of -55°C to +125°C. -
MIL-PRF-19500/291U
Abstract: This specification covers the performance requirements for PNP, silicon, switching transistors. Five levels of product assurance are provided for each encapsulated device type as specified in MIL-PRF-19500 and two levels ... -
DSCC-VID-V62/04730 REV A
Abstract: This drawing documents the general requirements of a high performance 3.3-V ABT scan test device with 18-bit universal bus transceiver microcircuit, with an operating temperature range of -40°C to +85°C. -
SMD-5962-88708 REV B
Abstract: This drawing describes device requirements for MIL-STD-883 compliant, non-JAN class level B microcircuits in accordance with MIL-PRF-38535, appendix A. Intended Use: Microcircuits conforming to this drawing ... -
DSCC-DWG-94039
Abstract: This drawing outlines the requirements for a specific member of a family of compact high contact density (.025 inch) two piece nanominiature electrical connectors. These connectors are intended for printed circuit board, ... -
SMD-5962-93166 REV B
Abstract: This drawing documents two product assurance class levels consisting of high reliability (device classes Q and M) and space application (device class V). A choice of case outlines and lead finishes are available and are ... -
MIL-PRF-39023/8C (1)
Abstract: This specification covers the requirements for style RQ210, variable, nonwirewound, precision resistors. -
MIL-M-38510/172C VALID NOTICE 1
Abstract: This specification covers the detail requirements for monolithic silicon, CMOS, logic microcircuits. Two product assurance classes and a choice of case outlines, lead finishes, and radiation hardness assurance (RHA) are ... -
DSCC-DWG-V62/13610
Abstract: This drawing documents the general requirements of a high performance wideband, low distortion, differential amplifier microcircuit, with an operating temperature range of -55°C to +125°C. -
MIL-DTL-28875C
Abstract: This specification establishes the general requirements for solid-state RF and microwave amplifiers and the verification requirements which must be met in the acquisition of amplifiers. Detail requirements, specific ...Subject(s) : bandwidth , coaxial , connectors , derating , flanges , gain , group delay , harmonics , hermetic seal , impedance , input power , isolation , microcircuits , modulation , noise figure , output power , phase linearity , pulse mode , screening , semiconductors , sensitivity , spurious , stabilization bake , VSWR , waveguide ,

درباره ما