DLA - CC - DLA Land and Maritime: Recent submissions
Now showing items 7941-7960 of 11453
-
MIL-DTL-27516G
Abstract: This specification contains the requirements for a non-collapsible, wire reinforced, synthetic rubber hose and hose assembly used with gasoline and jet-fuel. Intended Use: The hose and hose assembly required ...Subject(s) : Acrylonitrile , Butadiene , Cam locking type couplings , Coupling , Dematerialized water , dispensing , Drybreak , fuel servicing , Hydrocarbon fuels , Quick-disconnect , Reattachable screw on type couplings , Refueling systems , Sexless , Trucks , Wetbreak , -
SMD-5962-86873 REV B
Abstract: This drawing describes device requirements for class B microcircuits in accordance with 1.2.1 of MIL-STD-883, "Provisions for the use of MIL-STD-883 in conjunction with compliant non-JAN devices.
The complete ... -
SMD-5962-90638 REV E
Abstract: This drawing documents five product assurance classes as defined in paragraph 1.2.3 and MIL-PRF-38534. A choice of case outlines and lead finishes which are available and are reflected in the Part or Identifying Number ... -
MIL-P-642/13B
Abstract: This specification is approved for use by all Departments and Agencies of the Department of Defense.
The requirements for acquiring the plugs described herein shall consist of this specification and the latest issue ... -
SMD-5962-91618 REV A
Abstract: This drawing describes device requirements for MIL-STD-883 compliant, non-JAN class level B microcircuits in accordance with MIL-PRF-38535, appendix A.Intended Use: Microcircuits conforming to this drawing ... -
DESC-DWG-87031 REV E
Abstract: This drawing describes the requirements for a 8 pin, single-in-line, resistor network.Intended Use: Resistor networks are used in surface mounting applications where space is a major concern. -
SMD-5962-97586 REV A
Abstract: This drawing documents two product assurance class levels consisting of high reliability (device classes Q and M) and space application (device class V). A choice of case outlines and lead finishes are available and are ... -
DSCC-DWG-94032 REV A
Abstract: This drawing outlines the requirements for a specific member of a family of compact high contact density (.025 inch) two piece nanominiature electrical connectors. These connectors are intended for printed circuit board, ... -
DSCC-VID-V62/03601 REV A
Abstract: This drawing documents the general requirements of a high performance 16-bit bus transceiver with three-state outputs, with an operating temperature range of -40°C to +125°C. -
DSCC-DWG-10008
Abstract: This drawing describes the requirements for an open air, current sense, 5 watt resistor with standard leads.Intended Use: Resistors are intended for use in dc amplifiers, voltmeter multipliers, electronic ...

درباره ما