IEEE C57.124

Abstract

This recommended practice applies to the detection of partial discharges occurring in the insulation of dry-type transformers or their components, and to the measurement of the associated apparent charge at the terminals when an alternating test voltage is applied. <br><strong>Purpose</strong> <br>Partial discharge measurements in dry-type transformers may preferably be made on the basis of measurement of the apparent charge. Relevant measuring systems are classified as narrow-band or wide-band systems. Both systems are recognized and widely used. Without giving preference to one or the other, it is the object of this document to describe the wide-band method. General principles of partial discharge measurements, including the narrow-band method, are covered in IEEE Std 454-1973¹ [8]², IEC 270 (1981) [6]³and IEC 76-3 (1980) [5]. <br>¹This standard has been withdrawn, however, copies are available from the Institute of Electrical and Electronics Engineers, Inc., Service Center, 445 Hoes Lane, Piscataway, N.J. 08855, U.S.A. <br>²The numbers in brackets refer to those listed in Section 4. <br>³IEC publications are available from IEC Sales Department, Case Postale 131, 3 rue de Varemb&#233;, CH 1211, Gen&#232;ve 20, Switzerland/Suisse. IEC publications are also available in the United States from the Sales Department, American National Standards Institute, 11 West 42nd Street, 13th Floor, New York, NY 10036, USA.