درباره ما
NATO - North Atlantic Treaty Organization: Recent submissions
Now showing items 1141-1160 of 1523
-
NATO STANAG 2991
Abstract: The aim of this agreement is to register national acceptance of AAP-19(D). -
NATO STANAG 7013
Abstract: Scope:
The aim of this agreement is to establish a minimum definition of the hazardous zones around aircraft and fueling equipment when fuelling operations are in progress. -
NATO STANAG 2467
Abstract: Scope:
The aim of this agreement is to standardize, for use by NATO forces, the subjects found in formation standing operating procedures (SOP) used by national and multinational ... -
NATO STANAG 2389
Abstract: AIM
The aim of this NATO standardization agreement (STANAG) is to respond to the following interoperability requirements. -
NATO STANAG 7146
Abstract: AIM
The aim of this agreement is to standardize gases intended for use by NATO armed forces in aircraft cross-servicing operations. -
NATO STANAG 3797
Abstract: AIM
The aim of this NATO standardization agreement (STANAG) is to respond to the following interoperability requirements. -
NATO ANEP-52
Abstract: INTRODUCTION
The ability to conduct military operations at sea has long been of paramount strategic importance for all maritime nations. Defence of trade and prevention of seaborne attack are vital roles. In ... -
NATO AUIDP-1
Abstract: Purpose
To achieve the above stated goal, this publication:
• Explains the concept of UID
• Identifies roles and responsibilities for UID
• Provides guidance on which items ... -
NATO STANAG 4704
Abstract: AIM
The aim of this document is to enable and enhance international cooperation in metrology issues including test & measurement equipment management. This publication therefore contains the requirements, which ... -
NATO AECP-2(C) SUPP
Abstract: The scope of the manual is restricted to consideration of the possible hazards that are related to the use of radio and radar frequency transmitters up to 40 GHz. It is not intended to cover electromagnetic vulnerability ... -
NATO STANAG 2233
Abstract: The scope of this STANAG is limited to the use of RFID capabilities to support consignment and asset tracking and applies to NATO Operations. Nations (including NATO Agencies) are encouraged to utilize the provisions of ... -
NATO STANAG 1161
Abstract: The aim of this agreement is to register national acceptance of AMP-13 Vol I and all changes thereto. -
NATO ANP-4
Abstract: Introduction
Navigation in civil airspace is facing new challenges. As air traffic grows constantly, the separation between aircraft must be drastically reduced, hence requiring higher performances of ... -
NATO AOP-25
Abstract: INTRODUCTION
This AOP discusses the factors to be assessed in determining if munitions or weapon systems and their launching platforms (according to the applicability of STANAG 4327) are at hazard from events associated ... -
NATO STANAG 1173
Abstract: AIM
The aim of this agreement is to register national acceptance of ATP-1(E), Volume I including Change 2. -
NATO STANAG 3978
Abstract: AIM
The aim of this agreement is to register national acceptance of AEP-8(C) and all changes thereto. -
NATO STANAG 1194
Abstract: The aim of this NATO standardization agreement (STANAG) is to respond to the following interoperability requirements. -
NATO AQAP 2110
Abstract: Scope:
AQAP 2110 contains the NATO requirements for Quality. A system needs to be established, documented, applied, maintained, assessed and improved, and/or evaluated, in accordance ... -
NATO STANAG 3504
Abstract: AIM
The aim of this agreement is to specify basic technical requirements for electronic head-down displays (HDDs) based upon cathode ray tubes (CRTs). -
NATO STANAG 4605
Abstract: AIM
The aim of this agreement is to register national acceptance of AFLP-7.