درباره ما
NATO - North Atlantic Treaty Organization: Recent submissions
Now showing items 941-960 of 1523
-
NATO ATP-3.2.1.1
Abstract: PREFACE
The successful execution of operations in any campaign theme requires a clearly understood and widely accepted doctrine. This is especially important when operations are conducted by allied, ... -
NATO AEDP-3
Abstract: Introduction
The NATO Advanced Data Storage Interface (NADSI) working group has identified the Sanitization of non-volatile solid state, high density magnetic disks, and RAID memory elements as an ... -
NATO AEP-65
Abstract: Purpose
The aim of this Allied Publication is to guide project managers and paint specialists, to the test method defining the minimum quality of paint resistant to chemical agents for the protection ... -
NATO ATP-3.8.1 VOL III
Abstract: Aim
The purpose of this publication is to provide uniform standards and guidance to NATO forces on CBRN defence education, training and evaluation that will ultimately give them the capability to survive ... -
NATO STANAG 4293
Abstract: AIM
This document specified the acoustical environment in NATO surface ships in terms of Maximum Noise Levels (MNL), Noise Rating Curves (NRC), and Speech Interference Levels (SIL). An adequate acoustical environment ... -
NATO AMEDP3-(A)
Abstract: Purpose and Content
The purpose of the NATO AMedP-3(A), "Chemical Methods of Insect and Rodent Control" is to provide basic information on using pesticides to control disease vectors and pests during field situations ... -
NATO AEP-33(B)
Abstract: Purpose
The purpose of AEP-33 is to provide a guide to the specialized techniques and equipment used to establish the compatibility of materials intended for use in oxygen-enriched environments, including ... -
NATO STANAG 2345
Abstract: Scope:
The aim of this agreement is to protect personnel engaged in NATO operations from exposures to Radio Frequency (RF) fields, at levels that may be hazardous to health. ... -
NATO AMEDP-19
Abstract: AIMThe aim during military deployments is to take reasonable measures to respect animals in their environment, considering the possibility of tolerance and adaptation of ...
-
NATO STANAG 3967
Abstract: AIM
The aim of this agreement is to establish minimum design and performance standards for fixed system filter separator vessels and coalescer and separator elements that are used in those vessels for filtration of ... -
-
NATO STANAG 2294
Abstract: AIM
The aim of this NATO standardization agreement (STANAG) is to respond to the following interoperability requirements. -
NATO STANAG 4521
Abstract: AIM
The aim of this agreement is to ensure that nations develop mission-essential military equipments that will survive and be operational in an NBC-contaminated environment. -
NATO STANAG 5042
Abstract: The aim of this agreement is to standardize the symbols to be used by the NATO Armed Forces to indicate Military Telecommunications Facilities. -
NATO STANAG 3372
Abstract: AIM
The aim of this agreement is to standardize aircraft and ground equipment air and associated electrical half connectors for low-pressure air starting of aircraft engines to facilitate aircraft cross servicing and ... -
NATO STANAG 4517
Abstract: Ordnance.
For the purposes of this STANAG, an ordnance is defined as having a calibre normally greater than 40 mm and a rate of fire of less than 100 rpm and consists of a barrel assembly, breech assembly and ... -
NATO STANAG 1041
Abstract: AIM
The aim of this agreement is to register national acceptance of ATP-3(B) including Changes 1 through 5.