درباره ما
AA - The Aluminum Association Inc.: Recent submissions
Now showing items 21-40 of 48
-
AA ANSI H35.2(M)
Abstract: Foreword
This Standard is a revision of ANSI H35.2(M)-2003, which consists of logical values for long-term metric use rather than a restatement of ANSI H35.2 in metric terms. This revision consists of ... -
AA ASD-1(M)
Abstract: This standard provides systems for designating wrought aluminum and wrought aluminum alloys, aluminum and aluminum alloys in the form of castings and foundry ingot, and the tempers in which aluminum and aluminum alloy ... -
AA ADM
Abstract: The Specification for Aluminum Structures, hereafter referred to as the Specification, applies to the design of aluminum load-carrying structures, members, and connections.
This Specification ... -
AA TH56
Abstract: Aluminum electrical conductors today are being specified for nearly all new transmission lines and for most bare overhead distribution lines. Covered and insulated aluminum wire and cable have also been widely accepted; ... -
AA FDM15
Abstract: INTRODUCTION
A combination of high strength with light weight - outstanding properties of aluminum alloy forgings - has led to a rapidly expanding range of applications. Aluminum forging technology is also equally ... -
AA TAN-1
Abstract: FOREWORD
Listed in this booklet, in metric units only, are the tempers for aluminum and aluminum alloy products registered with The Aluminum Association but not contained in The Association's ... -
AA TEAL-1
Abstract: FOREWORD
Listed herein are designations and chemical composition limits for wrought aluminum and wrought aluminum alloys registered with The Aluminum Association. Numerical designations ... -
AA ANSI H35.3
Abstract: This standard provides a system for designating aluminum hardeners used primarily for the addition of alloying or grain refi ning elements or modifi ers to aluminum alloy melts. -
AA ATS-1
Abstract: Pusher-type furnaces are semi-continuous reheating/homogenizing furnaces. Unlike traditional furnaces where heating/cooling is done on a batch basis, with the pusher-type furnaces, each ingot has its own cycle and loading/ ... -
AA TP-1
Abstract: This standard procedure is applicable for determining the ability of grain refiners to reduce grain size during solidification of aluminum alloys in specified compositions under standardized conditions, and for examining ... -
AA GMA69
Abstract: These Guidelines were prepared for use by all personnel concerned or associated with activities involving molten aluminum, and particularly for those involved in everyday plant operations. All major steps in melting, ... -
AA ANSI H35.2
Abstract: Foreword
This Standard is a revision of “American National Standard Dimensional Tolerances for Aluminum Mill Products” issued in 2003 (ANSI H35.2-2003). -
AA ASD-1
Abstract: This standard provides systems for designating wrought aluminum and wrought aluminum alloys, aluminum and aluminum alloys in the form of cast ings and foundry ingot, and the tempers in which aluminum and aluminum alloy ... -
AA PK-1
Abstract: FOREWORD
Listed herein are designations and chemical composition limits for aluminum alloys in the form of castings or ingot registered with The Aluminum Association. This list is maintained by the ... -
AA SUP-1
Abstract: This publication explains and illustrates many aspects of the published standard tolerances for aluminum alloy extrusions, such as those contained in The Aluminum Association's Aluminum Standards and Data and the American ... -
AA QCA-1
Abstract: PREFACE
Visual Quality Characteristics of Aluminum Sheet and Plate has been compiled by the Technology Committee of the Sheet and Plate Division as a reference for those who have an interest in these rolled products ... -
AA DAF45
Abstract: The many proprietary designations for aluminum finishes can confuse users specifying finishes. To remedy this, the Aluminum Association developed a designation system broad enough to cover all types of finishes currently ... -
AA C-6
Abstract: ABSTRACT
Aluminum, especially when alloyed with one or more of several common elements, has been increasingly specified and used in packaging, architectural, building product, transportation, chemical, electrical, ...