درباره ما
MIL-F-43573A
FASTENERS, SNAP, PLASTIC
| contributor author | DLA - IS - DLA Troop Support - Industrial Hardware Items of Supply Standardization Code | |
| date accessioned | 2017-09-04T17:28:40Z | |
| date available | 2017-09-04T17:28:40Z | |
| date copyright | 06/28/1968 | |
| date issued | 1968 | |
| identifier other | CQINDAAAAAAAAAAA.pdf | |
| identifier uri | http://yse.yabesh.ir/std/handle/yse/151839 | |
| description abstract | – This specification covers requirements for two types of plastic snap fasteners (see 6.1). Intended Use: – The type I snap fasteners are intended for use on ponchos and shelter halves. The compressed thickness of foundation or fabric which can be used with these fasteners should not be less than 0.010 inch or more than 0.030 inch. If consideration is given to a fabric thickness outside the above range it should be thoroughly evaluated with this snap fastener design before adoption. The type II snap fasteners are intended for use on equipage items such as entrenching tool covers, tropical rucksack carriers, grenade cases and small arms ammunition cases. The compressed thickness of foundation or fabric which can be used with these fasteners should not be less than 0.030 inch or more than 0.156 inch. In the smaller thicknesses, only nylon fabric is recommended with this snap fastener. If consideration is given to a fabric thickness outside the above range it should be thoroughly evaluated with this snap fastener design before adoption. | |
| language | English | |
| title | MIL-F-43573A | num |
| title | FASTENERS, SNAP, PLASTIC | en |
| type | standard | |
| page | 9 | |
| status | Active | |
| tree | DLA - IS - DLA Troop Support - Industrial Hardware Items of Supply Standardization Code:;1968 | |
| contenttype | fulltext |
