ABMA - American Bearing Manufacturers Association
Browse by
Recent Submissions
-
ABMA 104
Abstract: This International Standard specifies the major boundary dimensions of single-direction and doubledirection thrust bearings with flat back faces.
In addition, it gives the minimum bore diameters of housing washers and ... -
ABMA 12.1
Abstract: This standard covers the characteristics that define metric design instrument ball bearings, their boundary dimensions, tolerances, internal clearances, classification for selective assembly, and recommended practices for ... -
ABMA 19.2
Abstract: This standard covers inch design radiai tapered roller bearings of various types, part numbering systems, tolerances, and fitting practices. For boundary dimensions, refer to manufacturers' catalogs. Tapered roller thrust ... -
ABMA 21.1
Abstract: This standard for metric thrust needle roller and cage assemblies and thrust washers includes:
Identification Code
Symbols and Nomenclature
Boundary Dimensions
Tolerances
Mounting Practice
All thrust ... -
ABMA 25.2
Abstract: This Standard gives the general plan for boundary dimensions, tolerances and terminology for recirculating ball, sleeve type, linear motion bearings.
This standard applies only to the size range covered by Table 1, ... -
ABMA 8.2
Abstract: Mounting accessories covered in this standard are commonly used for the location or fixing of ball and roller bearings to the shaft of a machine or mechanism. The purpose of the standard is to establish dimensions and ... -
ABMA 13411
Abstract: This International Standard specifies the required characteristics, inspections and tests, quality assurance and conditions for qualification, static radial loads, acceptance and delivery conditions for needle roller, ... -
ABMA 20
Abstract: This standard includes:
(a) basic plan for the boundary dimensions of metric radial ball and roller bearings;
(b) general rules for extension of the basic plans;
(c) dimensions and tolerances for snap ring ... -
ABMA 12240-2
Abstract: This part of IS0 12240 specifies dimensions and tolerances for angular contact radial spherical plain bearings.
The specified tolerance values apply to finished, angular contact radial spherical plain bearings before ...