MS16624 REV D (2)

RING, RETAINING, EXTERNAL, BASIC (TAPERED SECTION TYPE)

contributor author	DLA - IS - DLA Troop Support - Industrial Hardware Items of Supply Standardization Code
date accessioned	2017-09-04T16:19:27Z
date available	2017-09-04T16:19:27Z
date copyright	08/26/2013
date issued	2013
identifier other	TICEGFAAAAAAAAAA.pdf
identifier uri	http://yse.yabesh.ir/std/handle/yse/82863
description abstract	Intended Use: TO PROVIDE SHOULDERS FOR POSITIONING AND RETAINING MACHINE COMPONENTS ON SHAFTS. TAPERED DESIGN PRINCIPLE PERMITS RINGS TO MAINTAIN PRACTICALLY CONSTANT CIRCULARITY AND PRESSURE AGAINST BOTTOM OF GROOVE, COUNTERACTING CONSIDERABLE CENTRIFUGAL FORCE (SEE TABLE IV). RINGS FOR SHAFT DIAMETERS OVER 4 INCHES ARE SPECIALLY DIMENSIONED TO MAINTAIN BALANCE IN ROTATION. THE USE OF THE FOLLOWING FORMULAS ARE BASED ON THE FACT THAT THE RING WILL NOT FAIL IN COMPRESSION. LIMITATION ON USETHE FOLLOWING FORMULAS ARE NOT TO BE USED FOR BRITTLE MATERIALS SUCH AS CAST IRON, ETC.
language	English
title	MS16624 REV D (2)	num
title	RING, RETAINING, EXTERNAL, BASIC (TAPERED SECTION TYPE)	en
type	standard
page	11
status	Active
tree	DLA - IS - DLA Troop Support - Industrial Hardware Items of Supply Standardization Code:;2013
contenttype	fulltext