درباره ما
Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering
ASTM F1914-18
Organization:
ASTM - ASTM International
Year: 2023
Abstract: 11.1 The indentation and the residual indentation of resilient floor covering is important since the resistance and recovery from indentation reflects on the ability of the resilient floor covering to perform properly after installation. 11.2 The indentation of a resilient floor covering shall be measured using a specified type of indentor, flat or spherical, under a specified load and time. 11.3 The residual indentation of a resilient floor covering shall be measured after a specified recovery time. 11.4 See Table 1 for detailed testing and conditioning requirements by products (specification) type.
Collections
:
-
Statistics
Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2024-12-17T22:30:44Z | |
| date available | 2024-12-17T22:30:44Z | |
| date copyright | 2023 | |
| date issued | 2023 | |
| identifier other | f1914-18r23.pdf | |
| identifier uri | http://yse.yabesh.ir/std;jsessionid=190419C4AB017808E65B78A0B48BF7AE/handle/yse/337598 | |
| description abstract | 11.1 The indentation and the residual indentation of resilient floor covering is important since the resistance and recovery from indentation reflects on the ability of the resilient floor covering to perform properly after installation. 11.2 The indentation of a resilient floor covering shall be measured using a specified type of indentor, flat or spherical, under a specified load and time. 11.3 The residual indentation of a resilient floor covering shall be measured after a specified recovery time. 11.4 See Table 1 for detailed testing and conditioning requirements by products (specification) type. | |
| language | English | |
| title | Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering | en |
| title | ASTM F1914-18 | num |
| type | standard | |
| page | 5 | |
| status | Active | |
| tree | ASTM - ASTM International:;2023 | |
| contenttype | fulltext | |
| scope | 1.1 This test method covers procedures to determine short-term indentation and residual indentation of resilient flooring, when subjected to concentrated loads. 1.2 The test methods appear in the following order: Section Indentation by McBurney2 Test 4 to 10 Indentation and Residual Indentation 11 to 15 1.3 There are two procedures with their respective apparatus. The first (McBurney Test) is described in Sections 4 to 10 and is restricted to a spherical foot. It is only used for initial indentation measurements of VCT. The second is described in Sections 11 to 15 and has interchangeable feet with variable geometry. It is used to measure initial and residual indentation. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/F1914-18R23 |