درباره ما
Standard Test Method for Conductimetric Analysis of Water Soluble Ionic Contamination of Blast Cleaning Abrasives
ASTM D4940-25
Organization:
ASTM - ASTM International
Year: 2025
Abstract: 4.1 Abrasive media may contain ionic contamination naturally (for example, mineral abrasives), from manufacturing (quenching with contaminated water), transportation, storage or use (in the case of abrasive that is reused). Ionic contamination on the abrasive may transfer to the surface during abrasive blast cleaning, resulting in potential osmotic blistering, accelerated underfilm corrosion and premature coating failure. 4.2 This test method describes a shop/field procedure for assessing the level of conductive species on an abrasive. 4.3 Abrasive standards published by AMPP (AB) and ISO 11126 provide tolerance levels for water soluble contaminants of the abrasive.
Collections
:
-
Statistics
Standard Test Method for Conductimetric Analysis of Water Soluble Ionic Contamination of Blast Cleaning Abrasives
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T19:26:04Z | |
| date available | 2025-09-30T19:26:04Z | |
| date copyright | 2025 | |
| date issued | 2025 | |
| identifier other | d4940-25.pdf | |
| identifier uri | http://yse.yabesh.ir/std;jsessionid=19EDF98DDCEABA1787A29D9D7C83761E/handle/yse/343519 | |
| description abstract | 4.1 Abrasive media may contain ionic contamination naturally (for example, mineral abrasives), from manufacturing (quenching with contaminated water), transportation, storage or use (in the case of abrasive that is reused). Ionic contamination on the abrasive may transfer to the surface during abrasive blast cleaning, resulting in potential osmotic blistering, accelerated underfilm corrosion and premature coating failure. 4.2 This test method describes a shop/field procedure for assessing the level of conductive species on an abrasive. 4.3 Abrasive standards published by AMPP (AB) and ISO 11126 provide tolerance levels for water soluble contaminants of the abrasive. | |
| language | English | |
| title | Standard Test Method for Conductimetric Analysis of Water Soluble Ionic Contamination of Blast Cleaning Abrasives | en |
| title | ASTM D4940-25 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2025 | |
| contenttype | fulltext | |
| scope | 1.1 This test method describes a procedure for assessing blast cleaning abrasives for the presence of conductive-potential, ionic contaminants by determining the total concentration of water soluble conductive species using a conductivity test. 1.2 This test method does not identify the ionic species present nor provide quantitative results on each species. 1.3 This test method is based on a volume comparison among abrasives of similar sizes. A volume comparison is more closely related to surface area of the abrasives than is a weight comparison. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D4940-25 |