درباره ما
Standard Test Method for Hydrostatic Pressure Resistance of Waterproofing Membranes
ASTM D5385/D5385M-25
Organization:
ASTM - ASTM International
Year: 2025
Abstract: 4.1 This test method tests the hydrostatic resistance of a waterproofing membrane and can be used to compare the hydrostatic resistance of waterproofing membranes. It includes two specimen preparation procedures, one for post-applied membranes and one for pre-applied membranes. 4.2 No correlation has been established between the performance in this test method and that in the field.
Collections
:
-
Statistics
Standard Test Method for Hydrostatic Pressure Resistance of Waterproofing Membranes
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T19:26:18Z | |
| date available | 2025-09-30T19:26:18Z | |
| date copyright | 2025 | |
| date issued | 2025 | |
| identifier other | d5385_d5385m-25.pdf | |
| identifier uri | http://yse.yabesh.ir/std;jsessionid=19EDF98DDCEABA1787A29D9D7C83761E/handle/yse/343551 | |
| description abstract | 4.1 This test method tests the hydrostatic resistance of a waterproofing membrane and can be used to compare the hydrostatic resistance of waterproofing membranes. It includes two specimen preparation procedures, one for post-applied membranes and one for pre-applied membranes. 4.2 No correlation has been established between the performance in this test method and that in the field. | |
| language | English | |
| title | Standard Test Method for Hydrostatic Pressure Resistance of Waterproofing Membranes | en |
| title | ASTM D5385/D5385M-25 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2025 | |
| contenttype | fulltext | |
| scope | 1.1 This test method measures the hydrostatic resistance of a waterproofing membrane under controlled laboratory conditions. This test method is not suitable for systems that rely on confinement of the seams by the backfill since backfill is not part of this test method. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D5385_D5385M-25 |